Great video, can’t find them on the site though, searched forever. Should include a direct link.
@bagriders
Жыл бұрын
Here's a direct link to the product! www.bagriders.com/fittings/push-to-connect-fittings/bulkheads.html
@RS08COL
3 жыл бұрын
I can't find the SMC bulkhead drill bits anywhere in the UK, do you guys ship here?
@bagriders
3 жыл бұрын
Yes we do! We ship worldwide!
@b8gged
9 ай бұрын
do you guys use teflon and loctite to seal the threads or just loctite?
@bagriders
9 ай бұрын
To ensure effective thread sealing, we recommend opting for either Loctite 565 or thread tape-using both is unnecessary. While Loctite 565 may require some time for proper curing and can be a bit messy, thread tape provides a reliable alternative.
@orduna032
Жыл бұрын
Could you remove the line from the bulk head fitting once it’s installed?
@bagriders
Жыл бұрын
Yes you can!
@ridnlow976
2 жыл бұрын
no compression versions? i'll never use push/pull lock fittings ever again plastic or brass... asking for trouble
@bagriders
2 жыл бұрын
We use them all the time, no issues!
@itzfreakinjamie
2 жыл бұрын
So which one do I need to convert the quick connects on my Airlift 3P to accept hardline?
@bagriders
2 жыл бұрын
Email sales@bagriders.com and they can help you out with the fittings to run hard lines in your specific setup!
@souljayt8411
Жыл бұрын
Getting AN levvel lines on my setup 😉 can’t relate to this plastic talk🫣
@mohdshahrilzan5806
2 жыл бұрын
can i know what type of material you guys used for hardline setups?
@bagriders
2 жыл бұрын
For which part? Lots of different materials are used!
@Dan_car_
Жыл бұрын
Which loctite do you use??
@bagriders
Жыл бұрын
The loctite we recommend for sealing threads is Loctite 565 which can be found right on our website.
@Dan_car_
2 жыл бұрын
What drill bits do you use to make holes for this
@bagriders
2 жыл бұрын
We use these www.bagriders.com/fittings/push-to-connect-fittings/bulkheads/smc-dot-bulkhead-drill-bit.html
@Dan_car_
2 жыл бұрын
Thanks ! 🤙🏻
@ridnlow976
2 жыл бұрын
just start the hole with an 1/8" drill bit and use a step bit to fit... easy
Пікірлер: 21