cheers for the vid. i have been thinking of running full hardline set up to each wheel arch then nylon line for the last section to the struts basically i only want 4 places it could leak or fail aside from the connection to the tank. that an i read about flex of the lines due to pressure when cornering.
@squeakycleanair
10 ай бұрын
If you're building show truck yes. Regular cars is over kill if you run the appropriate air line etc. Blow outs happen when you purchase cheap Ali express suspension or install inappropriately where suspension components rub. If you're hearing horror stories their suspension was not installed appropriately and no one will tell you the truth when they're at fault.
@tma78
10 ай бұрын
@@squeakycleanair oh yeah i won't be doing it, it will be done by a workshop that only specializes installing air suspension. The ones i have found only use air ride or airlift.
@squeakycleanair
10 ай бұрын
@@tma78 I'm saying to run hardlines on each corner of the vehicle. Soft synflex dot approved is ok throughout the whole car then hardlines in trunk etc. some lowrider guys do it all up hardlines and polish them. Other than esthetics no point. Your car tho.
@timmytool1231
4 жыл бұрын
Thanks, having a real problem with my Firestone connectors, the ones you don't like, 1/4 push to fit, will try the other type as the Firestone connectors are very expensive.
@squeakycleanair
2 жыл бұрын
Not all PTC are bad. Could be a bad batch. Also SMC has started to step its game up!
@tombackes9557
2 жыл бұрын
Unsubscribed and thumbs down for the unnecessary vulgar obscene background garbage.
@squeakycleanair
2 жыл бұрын
Sweet!
@firmetatt2268
3 жыл бұрын
The fitting is garbage I still have problems with this trash very bad experience with the air lift to expensive and trash quality
@squeakycleanair
2 жыл бұрын
Ya. The fittings airlift sells are made by SMC. They started to produce better quality recently. Compression is always best!
Пікірлер: 10