I just love these videos, thanks! Keep the coming👍😊
@spirosangelopoulos3913
4 жыл бұрын
Thank you, you’re videos are so informative
@ebutuoyebutouy
4 жыл бұрын
Thanks for sharing.
@killerconsoles517
4 жыл бұрын
When I built my 2 stroke I used sandpaper to set the ring gap,just squeeze the ring against a folded piece, not sure if there is a issue doing this but the rings were nice and straights and the engine ran perfect.
@IsraelSocial
2 жыл бұрын
Thanks for the videos!
@trevhoag7814
2 жыл бұрын
Thank you for this
@AutodidactEngineer
3 жыл бұрын
For anyone wondering 22.000s is exactly 0.55mm
@mrrobertwolfiii1079
Жыл бұрын
Picked up at Ring's
@everythingrc2324
3 жыл бұрын
The bob ross of 1.8t’s
@Ostinslife1
4 жыл бұрын
YES so happy, also first
@danielveliciu3445
2 жыл бұрын
I'm attempting my first rebuild on my 1.8t AWP keeping everything stock.. Do I need to machine the bore down? Or can I just replace the rings with standard size or would i need to over size?
@melekk0
3 жыл бұрын
hey sir i found on an audi manual these specs -Cylinder Maximum deviation from the specified dimension: 0.08 mm. -Piston Maximum deviation from the specified dimension: 0.04 mm. So the standard diametre + max deviation is 81.01+0.08=81.09mm and piston 80.975-0.04=80.945mm is it normal to have a clearance of 0.145 (81.09-80.945) ? even tho the standard clearance was 0.04 (81.01-80.975) so the clearance of this engine can go from 0.04 up to 0.13 ?
@margperformanceengineering6434
3 жыл бұрын
What was the gap for the oil ring and did you file it?
@augustrodriquez721
3 жыл бұрын
is this compatible for the 2002 a4 b6 1.8t?
@mrrobertwolfiii1079
Жыл бұрын
Nice cross hatching.
@ivanfeijoogarcia7245
3 жыл бұрын
Std piston and ring?
@vsvenson
3 жыл бұрын
Yes
@vandettabuilds6641
4 жыл бұрын
Are you building that engine for your 944 ?
@vsvenson
4 жыл бұрын
Yes, I am.
@vandettabuilds6641
4 жыл бұрын
Van Svenson I love your videos. Is that the way to go instead of the LS I just put my 944 back together after a timing belt broke. I want a faster 944. Check out my videos if you have time and tell me what you think
@vandettabuilds6641
4 жыл бұрын
I have watched all your 944 videos over and over
@brkofobija
3 жыл бұрын
Wrong! Always grind one side from the outside to the inside!
Пікірлер: 22