I'm really looking forward to being advised that my AltMill is ready for pickup... at which time I'll go over this tutorial video one more time. Thanks for putting this together, Dan & Scott!
@dennisbracci9212
5 күн бұрын
great demo. cant wait order my machine.
@JoeSeppy
5 күн бұрын
For American viewers, Canadians say "Zed" not "Zee" for the letter "Z". So when Ben says "Zed axis" he is talking about the "Zee axis". Cheers!
@MatthewKelton
6 күн бұрын
A sawhorse works pretty well for the 3rd and 4th leg as well.
@jefflanphere857
6 күн бұрын
Thank Guys
@chubbyboy2242
6 күн бұрын
Yesss, been waiting for this. Thank you.
@jefflanphere857
6 күн бұрын
Yes Agree
@stevebarnett793
6 күн бұрын
I noticed you didn't use the 2x Eccentric Bushing, are they needed? Great job on the video!
@SienciLabs
3 күн бұрын
The eccentric bushings aren't needed for assembly, but are provided for adjusting the tram of the spindle mount if needed. We should have a resources page up this week explaining some of these details.
@bfreebabi5398
6 күн бұрын
Waah.. great demonstration ...
@philshel1
5 күн бұрын
I'm curious about squaring the table? He leveled it but did not even check for square or twist. Certainly they don't just trust the end cuts and the lengths to be correct, equal, and square? As nice as it is, this is still mass produced in China after all.
@SienciLabs
3 күн бұрын
All of the extrusions are cut and measured before they get packed to ensure the table is square after assembly. We also machine critical faces for extrusions if necessary to improve tolerances.
@philshel1
3 күн бұрын
@@SienciLabs So, you cut the extrusions in house and qc them all before packaging?
@ronsone8373
6 күн бұрын
EU warehouse would be nice.... I HAVE SOME SPACE FOR YA
Пікірлер: 14