SUBSCRIBE for future content!
Leave a LIKE if you enjoyed!
Aluminum thickness .063
Thanks for watching and keeping up with the build. The difficult thing about installing a sub-floor to a jon boat (my jon boat)that may not have one is getting the water to drain to the ransom so it can be pumped out by the bilge pump. I went with cpvc pipe i already had, but im not sure if that was the best idea. If I do it again, I will probably create some type of barrier between the port and starboard side, and leave a 4-5" channel down the middle. ____________________________________
Links to Products/tools/equipment
tbnation website-tbnation.net/?... Hatches-tbnation.net/c... Marine Sealant 5200-amzn.to/3fheTJL Pour Foam- amzn.to/2Zkei4i
2" hole saw- amzn.to/2C5XXaP
1QT mixing cups- amzn.to/2ZlScyE ____________________________________
Instagram- fireant_official_1
Facebook- fireant fishing ____________________________________
Recommended channels or Creators
TINY BOAT NATION on Facebook!
Mike Lopez- / michaellopeztbnation Anthony Jones- / anthonyjonesjonboats Nates Custom Boats and Accessories- / @tbnationoutdoors-nate...
____________________________________
DISCLAIMER: Some links provided above make commission, that gets put directly back into this channel for your entertainment and benefit. I am not a professional fabricator or boat builder, modify your boat at your own risk.
Негізгі бет Aluminum Subfloor and Pour Foam!
Пікірлер: 55