I did not know my amana had a filter at the bottom. Cleaned it all up. Did the 3 button repeat...and no error codes. Running a test cycle with some citric acid to freshen up the inside.
@dskribe9598
2 жыл бұрын
Thank you so much for this and showing us the other side of the code list! I had 6, 4 code and couldn't find the code guide anywhere until i stopped your video when you panned right! For me, it was just the float switch wasn't seated correctly. Got that sorted and my dishwasher lives again!! THANK YOU!!!
@4244john
Жыл бұрын
Where did you find the float switch?
@dskribe9598
Жыл бұрын
@@4244john Inside bottom front right. It's like a circular pedestal that sticks up. Push it down a bit, snaps into place. GL.
@Kentstatehippie
6 ай бұрын
Thanks for this video. I followed your instructions. The dishwasher just started working after the reset. : )
@sprenzy7936
3 жыл бұрын
Why doesn't the hi temp or heated dry not work for me? Doesn't light on
@cody5495
3 жыл бұрын
control board is bad
@makailah1019
2 жыл бұрын
How do I fix the control panel all the buttons work accept the hi temp button
@AaronHatcher
9 ай бұрын
Where can I find a list for the error codes?
@DLJoLo
2 жыл бұрын
That sequence didn’t work on mine. It went through the whole process but at the part where the clean light was supposed to light up it just went to its default settings and started a wash cycle. 😕
@krystlestoddard3407
2 жыл бұрын
Same thing happened when I did this. I’m trying to figure out why the dishes aren’t drying 🤔
@anne-mariepfligler2280
Жыл бұрын
Same thing for me, it just started a was cycle. My dishes don't dry & the jet dry never dispenses. 😢
@jerseygirl1125
2 жыл бұрын
maintenance people replaced our dishwasher with an amana similar to this one but i only get cold water WTH?
@mrbrown6421
2 жыл бұрын
How did you fix the hot water problem? Does your house have hot water? So lucky. My tent has no water at all, so we wash in the river.
@JoshuaRichards2010
Жыл бұрын
Probably hooked it up to your cold water tap instead of your hot water like it should have been.
@acwarner31
3 жыл бұрын
What was the button combination to get into servicemode?
Should be attached to the dishwasher or the removable panel
@pumanator1228
3 жыл бұрын
Or you can pause the video at 1:20 like I did and look that way
@guahanbassoutlaw5081
3 жыл бұрын
@@pumanator1228 finally someone with brains...hate stupid questions
@pumanator1228
3 жыл бұрын
@@guahanbassoutlaw5081 lol I know. Some people might not..have..a pause button... lmao 🤣
@alexandernavarre8704
2 жыл бұрын
Hi! My error code is 4, 3 but I was not able to pause the video to see that code and cannot find error code reference sheet online anywhere. Can you please reply back with what 4,3 indicates?! Thanks!
@jillbauerle1337
2 жыл бұрын
Did you figure out what it was?
@robot5546
2 жыл бұрын
kzitem.info/news/bejne/y6ek34NtbIqIfY4 4:3 indicates Motor not running. look and pause at time stamp 1:25 and you will see for yourself, but beware, I was getting the same code and messed around with it and got the motor back running...these things are just plain junk, gotta be some problem with the motherboard or something.
@robot5546
2 жыл бұрын
to add on I believe mine got switched to sales demo mode, not allowing the wash motor to run properly, thus I was getting the same error code as your 4:3, which turned out to be erroroneous, Run a full cycle in diagnostics mode to clear from demo mode and it should start running properly again.
Пікірлер: 32