Speechless! That's a fine looking Christmas present. I'm sure recipient will be very pleased. As always, thanks for you content.
@encarwoodworking
8 ай бұрын
Thanks again!
@ar6723
3 ай бұрын
Very nice. The wood choice looks great. Do you sell the carve file or is it available online?
@encarwoodworking
3 ай бұрын
If I remember correctly, this file was available on the file section of a FB group. Unfortunately I follow quite a few groups so I can’t specifically say which. I really appreciate the kind words!
@Mr.Peabody961
2 ай бұрын
What’s the secret? I’ve tried shellac but I still get bleed through into the wood. Even after sanding the wood turns black, the paint is dry, shellac is dry. Nice work btw.
@encarwoodworking
2 ай бұрын
Yea it can be difficult. I also get bleeding even after using shellac or lacquer. I really can’t say for sure but I do sometimes do a deeper depth of cut so it allows me to sand more material, which allows me to get most of the bleeding
@Mr.Peabody961
2 ай бұрын
@@encarwoodworking what tooling and setup did you use for the words? 60 degree? .1 depth?
@encarwoodworking
2 ай бұрын
@Mr.Peabody961 I’ll check when I get home but it was definitely 60 degree vbit.
@Mr.Peabody961
2 ай бұрын
@@encarwoodworking thanks, appreciate it. Btw what fonts work for you I’m still struggling with finding ones that consistently look good.
@encarwoodworking
2 ай бұрын
@Mr.Peabody961 it’s tough to say. If I’m carving a file I bought from Etsy or got from FB I pretty much leave it alone. But if I’m making something from scratch I always go through the list to see what works. I also browse dafont.com and see what looks cool.
@brandoncollins5694
8 ай бұрын
Man that is sharp! Do you mind sharing the file?
@encarwoodworking
8 ай бұрын
Not at all! Just not sure which is the best way to share. I can email if you like?
@encarwoodworking
8 ай бұрын
Try this m.facebook.com/groups/onefinitycnc/permalink/1136473460838848/ Got it from here
Пікірлер: 23