You can do this calculation yourself by dividing 1÷desired frequency (5hz) This will give you period T (0.20) After that, calculate the percentage of period T you want as your duty cycle (Period T= 0.20) * (Duty cycle 10% = 0.01) = On time = 0.020 The substract on time from period T and you get 0.1800
@colinward1581
2 ай бұрын
Steeve, in your example (7.83 Hz @ 5% DC) you need an On Time of ,0064, and an Off Time of .1213. However the ZK-PP2K only shows 3 places to the right of the right of the decimal point, so you can't input the complete on or off times. Am I missing something?
@aaronmarxsen8190
11 күн бұрын
Yeah what gives
@aaronmarxsen8190
11 күн бұрын
I’m hoping that maybe he just put the decimal point in the wrong place
@aaronmarxsen8190
11 күн бұрын
I’d like to explore that next setting as well when you hold down set for two seconds and it takes you to the next screen, which allows you to decide on how long you would like it on and off and then the amount of times which luckily enough you can start to infinity
@Steeve.
11 күн бұрын
@@aaronmarxsen8190 i am planning to make a video tjis winter on the topic :).
@aaronmarxsen8190
11 күн бұрын
Be really nice if you could address that question below this
@waynebagnall3611
4 ай бұрын
Great Steeve! Onward and upward! 😊 Always moving forward, always improving. 🎉
@aaronmarxsen8190
11 күн бұрын
Any idea what would be the best settings for that next screen as well?
@Steeve.
11 күн бұрын
@@aaronmarxsen8190 what arw we lookkng for exactly?
@projectdrivecitygrid
3 ай бұрын
Plz is possible power with 9v snap conector?
@Steeve.
3 ай бұрын
It is a very goid idea. I will look into it. :)
@BG-lr7zg
4 ай бұрын
Thanks for explaining the difference between gauss and weber in another video. Can mobile devices like what Robert Dennis makes provide the Webber you are talking about?
@8thsinner
Ай бұрын
I'm with colin here down below... Can you do a proper video on how to use this thing? Okay, so you've done the math for us but I haven't a clue how to input that cause it seems like theres 3 different screens or modes. I'm lost completely
@Steeve.
Ай бұрын
@@8thsinner I added to my list of videos! If you have urgen need for help email me at Steevebradet@outlook.com :)
@8thsinner
Ай бұрын
@@Steeve. I did email you the other day actually. Which, i've noticed you've just responded to...thank you. But yeah, a video would be good. Showing, directly on screen which part of your calculator refers to which mode, ideally with a couple of frequency examples. If i had an oscilliscope i'm sure i'd figure out the frequency part and modes but I don't have one yet. should change soon though.
@Rittter-x9c
3 ай бұрын
What method can be used to detect the flux distance away from the coil ? Thanks for the great info.
@Steeve.
3 ай бұрын
There are many ways. To mesure it you can use an gauss meter and oscilioscope, to observe it holding a magnet between your finger or watching a compas needel move. To name a few. :).
Пікірлер: 18