Use code “Beene” for 5% off at Battery Hookup!
These cells are cheap and can be a pain to mess with. Here's a process I've been using to put together packs with two cells in parallel. I made some mistakes along the way that were rookie level, feel free to point them out to me. I've been learning a lot with these builds. One thing I learned after this build was I should be doing 14s not 13s as if I want to run an AC inverter off this battery the voltage range works better with one more cell. And I've got room for it in the ammo can so may as well get the extra 58wh of capacity while I'm at it!
SPIM08HP Cells beenebrothers.com/SPIM08HPCells
13S Charger amzn.to/36nWwiI
M6 Lock Nuts amzn.to/3bQlDvN
M6x8mm bolts amzn.to/2zjW4pB
XT60 connectors, wiring, and heat shrink: amzn.to/2UDSnTF
Kapton Tape amzn.to/2zS1nwm
13s active balancer board amzn.to/3obUeeR
Ammo box: amzn.to/2LqQkQY
Some of the tools I use for putting it together:
Wire Strippers: amzn.to/2K0IdX6
Leatherman multi-tool: amzn.to/3babiLG
Hole Punch: amzn.to/2GViWz1
As an Amazon Associate I earn from qualifying purchases.
As a Battery Hookup affiliate I earn from some purchases made through links on this page.
#DIY #Li-Ion #Batteries
Негізгі бет Тәжірибелік нұсқаулар және стиль Ammo Case SPIM08HP Battery Build Without Spot Welder = 13S2P 700Wh
Пікірлер: 51