Overfilling
The video has subtitles in Russian, English, Greek, German and Albanian.
In order to start building the amphitheater, the first step is to find construction landmarks 0:33, which will allow you to correctly position the amphitheater on the ground.
Then we hammered a piece of reinforcement into the center of the future amphitheater and tied a wire to it. In the future, with this wire, like a compass, we measured the circle of the amphitheater 17:25.
When they made the markings, they began to dig the foundation pit 1:40. First they dug by hand and then used an excavator.
Stone processing 2:38 is one of the most difficult and demanding tasks in this project, because there are many stepped and even corner stones used. You can use any stones for construction, we used 3 different types of stones 16:17.
After we dug the pit, we begin to make the drainage system 3:31. The height of the drainage system is 25 cm. We have laid out large stones below, and small ones on top.
On top of the drainage system, we poured concrete and laid a 4:37 mesh reinforcement mesh.
We lay the masonry of the central circle of the amphitheater with a slope towards the pipes for water drainage, which we place on the drainage system under the outer ring of the amphitheater with a slight outward slope 18:25.
On the rough concrete we lay out the central circle of the amphitheater from the stones at 5:30. The principle of masonry is the same as that of stone road masonry (part 6.7): stonesuccess.vip/shcool/dorog...
The sun was laid out in the center of the amphitheater at 0:50. We worked for him a round stone in the center and stones-rays 6:15.
The composition of the mortar that we use for laying the pavement:
• cement М500 - 25 kg;
• screening out of fraction 10 mm - 3 buckets of 20 l each;
• screening out “granular sand” - 3 buckets of 20 liters each.
The composition of the mortar for masonry:
• cement М500 - 25 kg;
• screening out “granular sand” - 6 buckets of 20 liters each;
• lime in consistency.
The gaps between the stones in the laid out central circle of the amphitheater were filled with a liquid solution of 6:33. After drying, the seams were cleaned.
Then we started laying out the first stage of the amphitheater at 6:40. To do this, with the help of reinforcement in the center of the amphitheater and a stretched wire, the radius of the first step was drawn with a marker on the stones of the circle.
Behind the first row of stones we lay out the drainage system on dry 8:08, pour concrete on top and lay the reinforcing mesh.
We install pipes for electrical wiring in the rough concrete 8:30.
We line up the stones of the stairs at the level of 10:40. The height of each of the steps of the amphitheater is 35 cm. The length is 80 cm.
We measure the width of the step with a board template, focusing on the edge of the previous step 15:14.
We divided the main circle of the amphitheater with a construction joint at 13:10 into two parts at 12:15. Construction joints were made between the amphitheater and the walkways, and the retaining wall. For more information on construction seams, see our lesson road made of stones (part 6, 7) stonesuccess.vip/shcool/dorog...
We spread the second part of the central circle of the amphitheater 18:19.
On this central part, using the same "compass" we measure and lay the outer semicircle track 20:41. We put the stones in parallel on both sides of the path (we set the beacons), then we fill in its inner part. This is a technology for laying paths without a border (part 3) - for more details, see the website stonesuccess.vip/shcool/dorog...
Then we fill in the seams between the stones of the outer semicircle-path 28:15.
The composition of the mortar for filling the joints between stones in our case:
2: 1 - sand and cement M500.
When the mortar has dried up a little, we made a jointing (stripping) of the joints with a triangular scraper. After this procedure, the solution begins to dry even faster. When the solution will not leave marks on the stones at 29:19, we begin to do the final cleaning with a wire brush. For more details, see the website stonesuccess.vip/shcool/rassh...
We sweep away the remnants of the stripping with a soft brush and use a hydraulic press to wash the amphitheater.
We fill the steps of the amphitheater with earth and clay and tamp it 27:54.
For more information about the construction of the amphitheater, see our website stonesuccess.vip/shcool/amfit...
Our services stonesuccess.vip/service/
Негізгі бет Тәжірибелік нұсқаулар және стиль Amphitheater made of stone. How to build?
Пікірлер: 76