Thanks for posting this video! It helps me with my new drill press & just being able to lock down my table to begin with!!!
@RJBWoodTurner
10 жыл бұрын
Joe, This really is a great idea! Thank you for posting. Regards, Bob
@Rusty_ok
3 жыл бұрын
Brilliant. I am going to do this on mine.
@renbooth4147
10 жыл бұрын
Not a bad idea! “Live Long and Prosper”
@fredellis499
9 жыл бұрын
Just watched your video where you made disparaging comments about a US General drill grinding jig. I have used one of these quite successfully for over 25 years .After less than 10 bits to understand the techniques I have been able to quickly sharpen my drills with equal cutting edges every time. These are necessary when drilling metal as I normally do. Perhaps in the future you might do well to examine and try a piece of equipment before you make remarks
@Joewoodworker
9 жыл бұрын
Fred Ellis You are posting a bitch about something I said in an entirely different video? This video is dealing with a drill press table clamp. Are you Ok in the head? Obviously not. I mean, are you that goofy you can't state your thoughts when you're on that particular page but go off to an entirely different page and suddenly realize you have something to say about the previous page?
@ahmedalissa3861
3 жыл бұрын
Great, just mind when you need to move the table far down, the leaver will be obstructed by the base/floor.
@bobbg9041
3 жыл бұрын
Slick, but I think you could have done that with a bolt. Looks good.
@chugg535
7 жыл бұрын
Well, obviously I am not as witty as you, but the first thought I had with this design, is, what happens when you want to drill into something long, and the table needs to be down by the floor? Thanks for the entertaining videos.
@bobbg9041
3 жыл бұрын
Zzzzzzzzz
@ryandkaytv2426
5 жыл бұрын
"Don't steal my design for mass production...watch how I steal music for my video."
Пікірлер: 12