Excellent video. You didn’t skip over how to open and close the tank drain valve. Thank you.
@jds1vette
3 жыл бұрын
Look at all those ProPress fittings....nice.
@dothetontim
Жыл бұрын
No mention of opening the hot water valves on the fixtures supplied by the heater? They're not going to drain very well if you're not allowing air to replace the water in the tanks and filling them will be an issue if the air in the tanks can't be pushed out the hot fixtures to allow the cold water to fill the tanks again.
@SaintlySaavy
Жыл бұрын
Thanks for noting that things have to be equal for the tandem to work. We see to many out there that don’t understand that key detail
@adammoe605
3 ай бұрын
Excellent video
@nicoj3660
Жыл бұрын
You forgot to turn on a hot-water faucet in the house to let the air in so it would drain. Otherwise if you just open the valve, nothing will drain out of the hose due to lack of air.
@joannebudjak220
10 ай бұрын
Great video! I did it myself! Woohooo!
@girardhull6781
7 ай бұрын
Thank you, sir!
@jfarinacci0329
3 жыл бұрын
very good vid. thank you.
@coryeichorn9169
8 ай бұрын
Mine took a lot longer to drain completely during each step. Drain wide open with 4’ garden hose to floor drain.
@MikeB-jn2bu
3 жыл бұрын
What about cleaning the gas chamber filter at the bottom of the tank? I have a bradford white and had to clean it. Gets clogged with dust, dog hair and lint trips the high limit switch shutting the unit down.
@anabazan7757
3 жыл бұрын
This model of heater is the rg250t6n right? Does it always need a chimney?
@monty8008
Жыл бұрын
Thank you so much. Any idea where i can find the thermocoupler for MI40S6LN10? I can’t seem to find it online
@richardl3720
2 жыл бұрын
I have a Bradford White 75 Gallon gas water heater and the hot water side of the connection is badly corroded and I think it's because it's plumbed with dissimilar metals, copper & steel. Anyway, so I have to replace it and I'll replace the anode rod as well. The question I have is that my connections are 1" NPT rather than the standard 3/4." I looked through Bradford's specifications and this model shows 3/4" NPT. What gives?
@lrww5673
5 ай бұрын
Could this same procedure be carried out on a power direct vent model, Bradford White or is this only for an atmospheric version? thanks
@ingvarleskovar7169
2 жыл бұрын
Thank you for video. BW website says to release the pressure valve before draining. You recommend to not do that. Who is right?
@robertweinmann9408
2 жыл бұрын
My plumber has told me that pressure relief valves are not made very well these days and sometimes they will not shut off all the way when you manually open them. Then you're looking at replacing the valve. So he recommends not doing it. I've done it without issue, but who knows?
@richardsanchez685
2 жыл бұрын
Why do I have air pressure always, always, always coming out of the hot water side of my B W Natural gas heater? Any suggestions?
@ombasnet3488
3 жыл бұрын
My heater shuts off every within few minutes . Not sure what the deal is.
@Bomberjet
Жыл бұрын
How is this unit powered for electricity.
@honeyqk
2 жыл бұрын
Do you do anything with the pressure release valve?
@Davidblaine18
10 ай бұрын
He answer??
@honeyqk
10 ай бұрын
@@Davidblaine18 no
@Davidblaine18
10 ай бұрын
@@honeyqk so what you do
@honeyqk
10 ай бұрын
I had someone do it for me. He didn’t do anything to the pressure release valve. 👍
@Davidblaine18
10 ай бұрын
@@honeyqk I have a electric water heater no heat- turned off the Breaker and still got a shocked 😳😳 I’m not messing around anymore
@johnnyparker2128
2 жыл бұрын
Should I turn off the gas valve before turning off the heater from the control panel?
@Hi-bb5lo
Жыл бұрын
No
@johnnyparker2128
3 ай бұрын
@@Hi-bb5loThanks
@josephpuchel6497
3 жыл бұрын
Hello I have Bradford White power vent Is the drain valve a ball type valve or does it have a rubber washer that will break when I drain it.
Пікірлер: 33