Where are the grease fittings and fill ports located? Welder finished my teeth holders. Need to eat some trees!!
@BlakeMerckleTrucking
5 ай бұрын
If you look at the disk there is a hole with a grease fitting on the front of where the disk mates with the motor there's also one under the cover for the motor I believe that is also where the fill port is if you need to add fluid
@TheOutFitPropertyMaint.
5 ай бұрын
@@BlakeMerckleTrucking I will try to find them this evening. Thanks!
@TheOutFitPropertyMaint.
6 ай бұрын
Where do you find teeth? Did you have to tighten anything when you first got it?
@BlakeMerckleTrucking
6 ай бұрын
They are common teeth same as a diamond disk mulcher I get mine from xtreme wear parts. If ur tooth holders are not welded on make sure u put a stitch weld on each side of the tooth holders or you will end up messing the bolt holes up or throwing a holder which is really not good. Also the discharge side there is a deflector plate bolted to the end just go ahead an remove it it will run alot better without it
@TheOutFitPropertyMaint.
6 ай бұрын
@@BlakeMerckleTrucking thanks for the info!
@TheOutFitPropertyMaint.
6 ай бұрын
@@BlakeMerckleTrucking thanks for the info. I can hardly wait to mulch up some trees!!
@BlakeMerckleTrucking
6 ай бұрын
@@TheOutFitPropertyMaint. it does a surprisingly good job especially for the price the only other thing I'd tell you is to shim the quick attach plate on the mulcher so it's a tighter fit to ur machine while ur welding the tooth holders
@TheOutFitPropertyMaint.
6 ай бұрын
Is it HIGH FLOW? I dont have any paperwork with mine.
Пікірлер: 15