I bought one but how do you set the programs? I cant figure it out and the instruction manual is terrible.
@warsun8443
9 ай бұрын
Merry Christmas🥰
@bacarrs8396
9 ай бұрын
Merry Christmas Warsun!
@GhostGats
9 ай бұрын
Can you over torque with this or is there like a stop or clutch that prevents over torque
@GhostGats
9 ай бұрын
Also how does it work with low torque specs like 15ft lbs etc ?? What would you say the cons are about it ?
@AWDGSX18
9 ай бұрын
There is no over torque stop on this one. I'm not sure that i would use it for building engines, but it would be no problem for other jobs that don't require spot on tolerances. It's easy to manage when getting to the torque setting. If you take your time I don't think you would have any problems. Also, for the lower torque settings, I am sure it has that capability. As you can see in the video, it counts from the 0 setting. Cons would be the limitations on the torque stop. Again, it is a great tool for the price.
@noniespam
4 ай бұрын
So I ordered one of these but returned it the same day. The audible did not work.
@jeanclaudesegal4581
2 ай бұрын
you have to push the 2 middle buttons in at the same time while the unit is off so you can get the beep sound
@noniespam
2 ай бұрын
@@jeanclaudesegal4581 I did not find anything like that in the little booklet that came with it.. DARN
@roicarlesfontan6630
15 күн бұрын
i just bought one for 19 bucks on aliexpress (10 to 340 nm)...
@MrFernand0007
10 күн бұрын
same brand?
@roicarlesfontan6630
10 күн бұрын
@@MrFernand0007 Goyojo, works fine, i got the high nm one for car wheels and such, but if you want it for smaller things such bike parts and so on, you should buy the 30nm version. I might buy it in the future to have the complete range and precision in the lower end. I have the 10-340 nm one.
@MrFernand0007
10 күн бұрын
@@roicarlesfontan6630 I'm checking it out and it has good reviews i might grab one 🤔
Пікірлер: 13