Thanks for the tutorial, they are great. I wish we could see your mouse pointer.
@HatefKhaledi
7 жыл бұрын
Hi Pedram. I have now learnt how to show my mouse click in BandiCam. Hopefully from the next training ...
@aakashhnair7742
2 жыл бұрын
u r the real ansys god thanks a lot
@ahmedalnemr3282
6 жыл бұрын
i try to learn any thing from this videos but i still not familiar with that iam this content is pretty one but i have step back and have no knowledge thanks
@李仁德-e4e
6 жыл бұрын
Thanks for the tutorial. I have a question that the velocity is larger than inlet velocity (1m/s) at some position, is it correct ?? I have some similar result, and it confuses me.
@luizeduardom.
3 жыл бұрын
I believe it's due to the symmetry boundary condition. In the video it's too close to the boundary layer. When I drew a higher rectangle to make my simulation the maximum velocity was reduced and got closer to 1 m/s
@shuvochowdhury1115
2 жыл бұрын
Can you extend the tutorial to make u+ vs Y+ plot? It would be helpful because nobody say about it
@shakhromberdiev6377
3 жыл бұрын
Very Good. Thank you
@ac5rocks
5 жыл бұрын
How would one go with rotating the plate 30 degrees? I tried to do it in geometry and when I checked the final results, it came out the same as a flat plate without rotation, only the mesh was at an angle but calculating it as if it were flat. Thanks.
@idreeskhan-zp5ey
10 ай бұрын
But Re = 10k is not Laminar, it should be turbulent ?
@asmaemnebhi6626
6 жыл бұрын
Thanks for the tutorial,I don't obtain the graph into chart, and how can i import these results into matlab, I tried but unfortunately I failed.Thanks
@shashankjha6807
3 жыл бұрын
But reynolds number depends on dynamic viscosity not on viscosity .Re=(fluid density*velocity*characteristic length)/dynamic viscosity. How did yoy get the value of reynolds number 10000 from viscosity.Please explain?
@aakashhnair7742
2 жыл бұрын
get the dynamic viscosity value from dynamic viscosity vs temperature table( use room temperature ) for given fluid (air) then use ur formula and calculate density being 1.225 kg/m^3
@am-bt8xq
Жыл бұрын
Thanks so much, How can I contact you?
@alizulfiqar7547
Жыл бұрын
can you plz share the complete ansys file
@prayaggore4392
6 жыл бұрын
bhava! thanks bhava
@subratadutta7710
2 жыл бұрын
Your cursor is not showing. It is becoming a problem when you are clicking on which option and sometimes how you are doing. Everything else is great.
Пікірлер: 18