Por-patch, never knew! I’ll check it out, thanks. I liked and subscribed, Dave👍
@nicholaspaley876
10 жыл бұрын
Very nice used this the same process 15 years ago. Then applied there white por marine coating. All this time later the floor is like bulletproof. Should of done in around the sunroof drains oh well and under the frame. Good stuff.
@Pontonio1991
10 жыл бұрын
1 coat wont be sufficient - it will rust again. There are microscopic pin holes within a single layer, that applying two coats will remove. Water, and air will get into these holes and rust the metal below.
@lifeisgood12341
9 жыл бұрын
If you wanted to keep that area dry for longer throw in a couple of the silica gel packets that you find in bags and stuff
@BeingWolfy
11 жыл бұрын
Thanks for your videos, guys.
@sunbugs
11 жыл бұрын
Your lid on your qt can is going to be glued forever, the plastic will melt and it will all become ONE (kinda sounds spiritual)
@VwRosstorations
7 жыл бұрын
Thanks for sharing..
@myrongaines5542
9 жыл бұрын
you need to pre treat the areas with chemical treatments from por15's kit,as well as apply 2 coats. And u need a mask because this stuff is toxic to breath
Пікірлер: 9