This project interfaces Flame Sensor and MQ 2 Gas Sensor with Arduino and learns about all the procedures needed to develop Arduino Fire Alarm System. The flame sensor module has a photodiode for light detection and an op-amp for sensitivity monitoring. It is used for fire detection and makes a HIGH signal. Arduino detects the signal and alerts the buzzer and LED by turning it on. The flame sensor utilized is a flame sensor based on IR.
The MQ 2 sensor has an electrochemical sensor that varies its resistance to different flammable gas concentrations.
Components Required for Arduino Fire Alarm Project:
1. Arduino Uno × 1 amzn.to/3mYHkAN
2.MQ-2 Gas & Smoke Sensor × 1 amzn.to/3zYfAT1
3. Flame Sensor × 1 amzn.to/3zYfAT1
4. LED and resistor kit × 1 amzn.to/3eej3CU
5. Buzzer ×2 amzn.to/3xL0QFc
6. Breadboard × 1 amzn.to/2RLJpEM
7. Jumper wires kit × 1 amzn.to/2QEE41B
8. USB cable type A/B × 1 amzn.to/3mYQNrP
Arduino Fire Alarm Code, Circuit Diagram, and much more:
► arduinopoint.com/arduino-fire...
Visit www.arduinopoint.com for more projects.
Like my page on Facebook:
► / arduinopoint
Follow me on Twitter :
► / arduinopoint
#Arduino_Project #Arduino_Fire_Alarm #Flame_Sensor
Негізгі бет Ғылым және технология Arduino Fire Alarm Project Using MQ2 Gas and Flame Sensor
Пікірлер: 51