Great Minds! I've also decided to use those side markers as Turn Signals. 😎
@tamiyatruckbuilding7426
2 жыл бұрын
Hi Carmine. I've finished the cab build now and all wiring is done except for two side repeaters, which aren't fitted yet. I'm toying with a video showing the Brier lighting configuration.
@CarminesRCTipsandTricks
2 жыл бұрын
INDEED we are in the section where I'm getting the most valuable information!! I completely FAFFED me first Beier install, as I told you a few months ago. 😲😖 I've been Soldering for nearly half a Century.... but it says nothing about my skill level. Compared to you, I use at least 6X the Solder that you do!! I've damaged several Resistors along the way. I'm going to try it your way next time.... I'm sure it will turn out better! Thanks Colin!
@tamiyatruckbuilding7426
2 жыл бұрын
Hi Carmine. If your work is clean and fluxed and the wires are parallel solder flows very easy.
@user-qg7hf4ly2s
Жыл бұрын
what resistor are you using? How many ohms
@tamiyatruckbuilding7426
Жыл бұрын
Depends on supply voltage. If using NiMh 7.2v, then 270 Ohm. (Supply Voltage - LED voltage)/LED Current. Vs = 8.2v(max charged) - LED 3v = 5.2v/0.020A (20mA) = 260. Nearest upper value is 270.
Пікірлер: 7