Im liking this simple upgrade build. I want to use this for 3S. Think the XT30 can handle it? Where did you get the servo mount from?
@B1zer_rc
Ай бұрын
I don’t think xt30s can handle 3s very well
@B1zer_rc
Ай бұрын
I ran a 3s xt30 on a fpv and it melted so idk
@ChrisCroft77
Ай бұрын
@@B1zer_rc xt30 shoudl take continuous 30 amps. But there are plenty of low quality xt30s you can buy.
@rocketpunchrc7143
24 күн бұрын
No issues so far, havent melted my connector or anything on 3S. No hot temps either. Just make sure if you do use xt30 that they are Amass brand. I chose this connector because of its size and it can handles peaks of up to 65amps
@rocketpunchrc7143
24 күн бұрын
Servo mount I bought locally but its a Powerhobby but I recommend Ecopower one as the Powerhobby isnt machined with the lip to lock into chassis, it juat sits on top. The Ecopower locks into slots which is much sturdier
@coltonseybert692
Ай бұрын
Did you bind the reciever to the stock slt 2 or could you bind it to the stock transmitter rather ?
@rocketpunchrc7143
24 күн бұрын
Stock receiver is built into esc so I swapped in a FG4S receiver so i can use my Noble NB4
Пікірлер: 11