Bought the analog version on 4s. Very nice quad and well finished like all Diatones products. Just finished making a 4s li-ion 2600mah from molicel p26a cells, so going to see how that fairs. They have made a cracker with this one I think. It's super light weight for a 5" quad. I do like the Rekon 5, well thought out but, the L5 was the one for me. Loved the attention to detail with the l5, I bought the L4 too now! Keep up the good work bud :)
@edfroxt7294
3 жыл бұрын
Rekon 5 for me - one of the nicest looking quads)) Ordered one frame to build myself)
@bobmarkson5343
2 жыл бұрын
I already bought a Roma, now I'm looking at Rekon 5's! Great vid
@steveeb00
2 жыл бұрын
Just got the rekon5. The antenna still mounts next to camera. Makes takeoffs and landings a PITA. Landings cause the quad to flip (especially with air mode) and grind the spinning props in the ground.
@MCsCreations
3 жыл бұрын
Awesome flying and review, Dave! 😃 All I can talk about is the electronics and both companies are fantastic at it. I never had issues with any of their electronics (and I use them for a long time)! Anyway, stay safe there with your family! 🖖😊
@DaveCFPV
3 жыл бұрын
Agreed both have great electronics
@Steve-O_FPV
2 жыл бұрын
Not impossible to find without buzzer. I dropped Explorer 4" (no buzzer at all) fell 350 feet into deep weeds about a mile out. I had the GPS coordinates up until the video went out which was about 7 feet above the ground, mapped it, followed the arrow on my phone GPS 1000 feet out from the road in a field with super high weeds everywhere and went right to it. The battery had run dead but did not come off. No buzzer needed.
@serang
2 жыл бұрын
I had my explorer 4 crashed into bushes, with buzzer and GPS. It was still pain to find the quad.
@mrorloff3152
3 жыл бұрын
If I use naked gopro on rekon 5 there is a problem with satellites, often in flight the number becomes less than 6. Is there a solution to the problem?
@kosmonautfpv4920
2 жыл бұрын
Hey Dave. I'm considering putting all my rekon 5 parts on a diatone frame. I'm getting really bad frame resonance and oscillations with my rekon 5 and have since I got it fresh out of the box. It's fun to fly but it ruins pretty much every long range cinematic video I try to make with it due to the nasty oscillations
@zira_fluff4105
2 жыл бұрын
I am interested in both of these models. I have read that the Roma L5 will fit the DJI AirUnit (original). Can the Rekon 5 fit the DJI AirUnit? That would likely tip my choice to the Rekon 5 as I have an unused DJI AirUnit (and camera) and don't want to have to buy a DJI Vista. Thanks!
@babc142
3 жыл бұрын
Hi Dave, what ESC settings do you recommend for 4" and 5" LR efficiency? Would you suggest 48kHz PWM for 1404s? And timing?
@Maxbl4
3 жыл бұрын
I have rekon 5 with these diatone 1700kv motors, it flies quite well with lighter batteries, up to 6s1400, but when i put 4s 21700 li ion pack, it get a lot of jello and mid throttle oscillations, can you suggest where should i move the tune? Also for the antenna mount, now with elrs it is not needed :) just today i flew 10km out on rekon 5 with elrs 2.4 at 150hz and 100mw, zero issues, 99lq all the way, quite possibly i could fly there with 50mw. So I don't think crossfire is ever need on quads anymore ;) and 2.4 antenna is just tiny
@nakedbearfpv1209
3 жыл бұрын
Great video by the way. You are one of the reasons I got into long-range. Does anyone have a link to the Immoral T print on the Rekon frame?
@camarochip
3 жыл бұрын
Thank you for this video cuz I was looking at the L5 and the Recon, I do wish my image look as good as it does in this video with my air unit,at 50 mbps..dji camera, grass and the trees dont look as sharp as yours.
@TheDroneNerd
3 жыл бұрын
Where can I find the tool to tighten the Rekon 5 nuts on the bottom plate ?
@unything2696
3 жыл бұрын
Can you even tighten them?
@TheDroneNerd
3 жыл бұрын
@@unything2696 of course you can it’s a fastener….When and if your arms are a bit loose like mine are now, you will want to tighten that up.
@jhughes2286
3 жыл бұрын
The Diatone looks soo much heavier how can that be!
@stormriderfpv
3 жыл бұрын
motor cable protections
@Maxbl4
3 жыл бұрын
Gps on diatone does not work because of super noisy esc. On a normal stack, you can put grounded emi shield between esc and fc and gps work very well immediately. But it's not possible with this aio 🤦
@aarem01
3 жыл бұрын
what are the props of the L5? I bent 2 and cant find the specs
@AMV-FIGHTING
3 жыл бұрын
Wish you give me a change to try this awesome quad last week my motors broke
@silin1982
2 жыл бұрын
PIDs? Dump? Diss!
@andrewnguyen3339
3 жыл бұрын
You like more the reckon motors or the diatone motors?
@andytaylor3321
3 жыл бұрын
i have broke all 3 of the bottom plates on the flywoo exporer lr 4in any tips on were to buy more sir pease and thank u my wife wont let me buy another so i have to fix my 3 lol i wanted the rekon 4 great builds and tips thanks dave i really appreciate all u do for us pilots thanks buddy i am from ontario canada
tried to fly my L4 in ACRO when I tried to roll it freaked out and hit the ground
@m.melgui4452
3 жыл бұрын
Congrats...
@lostdeath4202
3 жыл бұрын
@@m.melgui4452 Diatone put a label on it saying to use their PIDs and rates I did and that’s what happened lmfao
@divingfalconfpv4602
3 жыл бұрын
I was going to just build an ultralight 6" and then bam u came out with a 6" .. now I think I'm order that.. I have ur explorer lr. I built ur Rekon5 (did 40+mins plus on 3000mah li-ion video on page) Now I'm trying to get the 6".
@rawpicsfpv3516
3 жыл бұрын
Hey Dace, reicht ein 35V 470uf für einen Rekon4 fr mit fettec aio?
@DaveCFPV
3 жыл бұрын
Ja :-)
@damianomotta1809
3 жыл бұрын
Dayummmm
@wildestanimal
3 жыл бұрын
hi Dave, will there be a Rekon 7 inch?
@DaveCFPV
3 жыл бұрын
Yes the Rekon 7 Pro. There are pictures and flight footage of the prototype on my Instagram
Пікірлер: 40