Sorry for late reply, AL009: Excessive deviation of Position Command Causes Checking Method Corrective Actions Parameter P2-35 is set too small Check the setting value of parameter P2-35 (The warning condition of excessive position deviation). Increase the setting value of P2-35 (The warning condition of excessive position deviation). The setting of the gain value is too small. Check if the setting value is appropriate. Correctly adjust the gain value. The torque limit is too low. Check the torque limit value. Correctly adjust the torque limit value. Excessive external load Check the external load. Reduce the external load or evaluate the motor capacity again.
@hamara4457
3 жыл бұрын
Do you know the solution for alarm 009?
@yapselectro2946
2 жыл бұрын
Sorry for late reply, AL009: Excessive deviation of Position Command Causes Checking Method Corrective Actions Parameter P2-35 is set too small Check the setting value of parameter P2-35 (The warning condition of excessive position deviation). Increase the setting value of P2-35 (The warning condition of excessive position deviation). The setting of the gain value is too small. Check if the setting value is appropriate. Correctly adjust the gain value. The torque limit is too low. Check the torque limit value. Correctly adjust the torque limit value. Excessive external load Check the external load. Reduce the external load or evaluate the motor capacity again.
@qutubkhan8113
Жыл бұрын
Please AL.009 Discuss and Connecting Wiring Image
@juanlezama7930
2 жыл бұрын
Please solution Al009
@atulram3111
3 жыл бұрын
Al.o11 ka alarms kese remove hoga
@saurabhshakya545
2 ай бұрын
Encoder cable check
@kostasvasiliou8290
2 жыл бұрын
Do you know the solution for al022?
@yapselectro2946
2 жыл бұрын
Sorry for late reply, AL022 Main circuit power lack phase: Check if RST power cable is loose or does not connect to the power. This alarm occurs when no power connects to single phase servo drive.
Пікірлер: 15