I am a subscriber, but my duties as priest take a lot of time from me. I also an rc pilot and followed your flying videos for a long time, what I need to know is how to break in a new .46 evolution engine
@jack42112
8 жыл бұрын
BONJOUR COMBIEN TU OUVRES TON POINTEAU MERCI
@Hans45
3 жыл бұрын
Hi, is the what does the "remote needle valve" you are turning on do? I bought a kyosho hype, but it's missing it. the carburettor only has a idle screw, but no high speed valve. Would this remote valve work as one? thanks
@elpunto231
2 жыл бұрын
Hello this is high speed needle set.. for high rpm...you need it to run the engine
@Hans45
2 жыл бұрын
@@elpunto231 Better late than never! Thanks
@wojciechpvb7132
8 жыл бұрын
hi - what is the fuel consumption of that thing ?
@elpunto231
8 жыл бұрын
+Wojciech PVB hello,at 2/3 of throttle it is 200cc for 16minutes of flying...
@snipereliete
4 жыл бұрын
Do all nitro engines need a breather pipe like the way your tank is configured.I'm getting back into nitro after 20 years and I've got no one to help me.any help would be great.
@elpunto231
4 жыл бұрын
snipereliete yes becouse almost all engines needs preasure in tank to run..
@snipereliete
4 жыл бұрын
Thank-you very much for your help.I appreciate u taking the time to help me.like I said I have no one to help me anymore.my father passed away.he was the nitro master.I'm going to fly nitro again for him.thanks mate.
@elpunto231
4 жыл бұрын
snipereliete you can check my brother chanel and me there is a lot of nitro stuff there..Robert Petrinčič
@snipereliete
4 жыл бұрын
I am a massive fan of both u and your brother.I understand about the fuel lines running from muffler to the tank and the carbireta but what is the third line u have running out of the tank.
@elpunto231
4 жыл бұрын
snipereliete the third one is for putting fuel in tank...
@027joe
6 жыл бұрын
hello are these asp engines made in china.?
@elpunto231
6 жыл бұрын
027joe yes they are...i have a lot of them and they run just perfect...
Пікірлер: 16