I liked the Kobalt hex bit adapter, where can I source the knurled adapter ?
@titigoy4255
2 жыл бұрын
Thank You very much ! 👍
@starastronomer
2 жыл бұрын
Glad you liked. Do you have a Mach2 or are you getting one?
@samirpatel8585
3 жыл бұрын
Hi will this work on AP Mach1?
@starastronomer
3 жыл бұрын
Samir Patel That I do not know. I had a Mach1 years ago but used a Pelican case with a custom insert I made for it.
@samirpatel8585
3 жыл бұрын
@@starastronomer thanks for the prompt reply. I’m going to check it out tomorrow at Home Depot.
@starastronomer
3 жыл бұрын
Thanks. Please let me know if it works. My initial thought is yes but cannot say for sure.
@samirpatel8585
3 жыл бұрын
@@starastronomer quick question when you store the mount in the box do you loosen the clutches?
@starastronomer
3 жыл бұрын
@@samirpatel8585 No, not for the Mach2 because it has a dead stop so as not to allow the internal cabling to get twisted. It states in the user manual not to let the mount "hit" hard against that stop or it may become damaged. I believe it is a pin but can't say for sure. I just do this to ensure it does not move too quickly as I took out the mount or was putting it in the case. As to the Mach1 that won't be an issue and if need be you can loosen the clutches to get it to fit. By chance and with my latitude I can put the Mach2 in the case the way I do. Did you get the Ridgid case?
Пікірлер: 11