It's strange none of the big channels review this case, possibly because it's mATX and for whatever reason people either prefer ATX or Mini-ITX.
@localtechexperts
5 ай бұрын
Its actually one of my favorite MATX cases at the moment. A little bigger and more expensive than most but its worth it IMHO
@waterfelon33
5 ай бұрын
@@localtechexperts I like it too, if I had matx board It would be a tough choice between this or Deepcool CH370 with all its nifty little features despite somewhat smaller size and less space for cable management, it's still beautiful.
@yilongwei4592
3 ай бұрын
@@waterfelon33 heard ch370's material aren't very thick, and since you are looking at these two cases I would recommend Cougar MX600 mini, similar form and size, a bit cheaper than A21, but offers two 160mm fan, good quality.
@waterfelon33
3 ай бұрын
@@yilongwei4592 I'm not looking to buy it since I don't have matx or itx board just admiring the looks of them. Also both A21 and CH370 cost the same where I'm from which is about 60 euros. As for Cougar I can't find MX600 mini, only Full tower variant.
@yilongwei4592
3 ай бұрын
@@waterfelon33 MX600 mini is a fairly new product, it's exclusively on the China's market for now, for motherboards, I'm fully committed to M-ATX, I think it's a nice balance between ATX and ITX, wide range of products which means reasonable price and rich features
@abep.3110
10 ай бұрын
Does the front panel keep dust out since it has no mesh filter?
@localtechexperts
10 ай бұрын
Good point.. The mesh on the front should do an ok job but yeah it is kind of open.
@GordoVAC
9 ай бұрын
Bro, the Y cable on the graphics card can affect the consumption performance and can break your graphics card. Try putting mod cable, it's nice and cheap, I'm using Google Translator, greetings from Uruguay
@localtechexperts
9 ай бұрын
Greetings from Australia.. The RX5600XT is not that power hungry considering I have a nice 650w in there.. Have never had issues with the Y connector on these. Though would suggest using two different cables where possible. Mod cables joined to the Y connector wont add any benifit.
@Thedzdev
3 ай бұрын
Hi, is the front panel mesh or just plastic? Thanks, nice review.
@localtechexperts
3 ай бұрын
Thanks yeah its mesh.
@cminuets6859
3 ай бұрын
Love the build quick question will i be able to fit an atx motherboard in the asus a21 case?
@localtechexperts
3 ай бұрын
Nope sorry this one is MATX only
@aydncan5788
7 ай бұрын
Hey thanks for the video, how you setup rgb of fans? Did you use rgb multipler? Need help :)
@localtechexperts
7 ай бұрын
The fans in this one are a pack of 5 that come with a proprietary fan controller. Something like www.amazon.com/dp/B0C2V9X6XX Do you have a fan kit already? are they standard 3pin 5v argb fans?
@axstra2557
3 ай бұрын
Sorry another question too, will 3 fans be enough for this case (for like 2 months)
@localtechexperts
3 ай бұрын
If using only 3 fans to start would probably go with two intakes at the front and one exhaust at the rear until you can fill out the extra spots.
@axstra2557
3 ай бұрын
Okay I'll do that thank you again @@localtechexperts
@CLJ_30
6 ай бұрын
Hello, does the "Arctic liquid freezer iii 280mm" radiator fit into the top part of the Asus A21 case? I have a "TUF GAMING B650M-PLUS WIFI" motherboard to specify the information more. Thanks
@localtechexperts
6 ай бұрын
Specs state top can fit radiators up to 360mm
@kazuviking
2 ай бұрын
@@localtechexperts Arctic AIOs are way thicker than other AIOS and that can cause isseus.
@localtechexperts
5 күн бұрын
Ahh I see.. Thickness shouldnt be too much of an issue quite alot of clearance there.. Only thing is it could conflict with the rear fan mostly.
@axstra2557
3 ай бұрын
Hey i have a question will i be able to vertically mount rx 7800 xt steel legend in this case?
@localtechexperts
3 ай бұрын
There's no specific vertical mount points unless you get a special bracket that turns horizontal ones into vertical.
@axstra2557
3 ай бұрын
@@localtechexperts alright thanks
@Sul3jman
Ай бұрын
what motherboard did you use for this build?
@localtechexperts
Ай бұрын
GA-Q170M-MK ... Not the most up to date motherboard but it is MATX so fits the form factor and I have a stack of them.
@Sul3jman
Ай бұрын
@@localtechexperts i see, thank you
@FranceFamily-ef9pg
10 ай бұрын
what can i use instead of RX 5600 XT? Can i use individual fans?
@localtechexperts
10 ай бұрын
Lots of GPUS will fit up to 380mm long. Not sure what you mean regarding the fans.
@eternal8productions
8 ай бұрын
hi, does it come with the front ventilators ?
@localtechexperts
8 ай бұрын
This one came with no fans. I had to add the fans myself
@TedTeddy-ej3dp
2 ай бұрын
So does this case not have power button and reset button connectors?
@localtechexperts
Ай бұрын
Yeah it does..
@TedTeddy-ej3dp
Ай бұрын
@@localtechexperts Interesting. I ordered it and it didn't arrive with those connectors. I'm guessing I should return it then?
@localtechexperts
Ай бұрын
I believe its one of those all in one Front panel connectors. Looks like a usb2 connector but its actually the front panel connector.
@TedTeddy-ej3dp
Ай бұрын
@@localtechexperts Thank you
@abdulkadir-i2d
7 ай бұрын
Can i use an b650 motherboard
@localtechexperts
7 ай бұрын
As long as you get a MATX sized board. These are MATX cases.
@TheLautaro98
3 ай бұрын
Thank you for showing! I have a RTX 3070 Trio, that will fit right in innit?
@localtechexperts
3 ай бұрын
Hrm. I would assume so. The case specs say GPUs up to 380 mm in length.. Looking at the dimensions of the rtx 3070 gaming x trio says it is 323mm long.
@TheLautaro98
3 ай бұрын
@@localtechexperts Thank you so much!
@dotamaze
7 ай бұрын
No front USBC that's the only gripe about this case
@localtechexperts
3 ай бұрын
Maybe next year they will bring out one with USB C.
@abdulkadir-i2d
7 ай бұрын
Can i use an b650 motherboard
@localtechexperts
7 ай бұрын
As long as you get a MATX sized board. These are MATX cases.
Пікірлер: 48