We ordered one today should be here tomorrow so we will see
@intaniik5743
9 ай бұрын
Do you absoloutely have to do this??? I've been seeing a lot od videos of what seems like people not doing this, just putting the piston on and cylinder. ???
@andrewcook7547
6 ай бұрын
On the Athena website it specifically says “This cylinder kit can be installed without making any changes to the engine crankcase.” I don’t know exactly why he cut that thing up😅
@andrewcook7547
6 ай бұрын
Don’t listen to me I would 100 percent do this. after reading more closely you are required to. My mistake
@tylerraffensberger3756
10 ай бұрын
You didn't com up with shavings because aluminum isn't magnetic bud lol.
@Chris_Does_Everything
9 ай бұрын
LOL is right! Not sure what I was thinking there, good catch!
@omicronomicron9613
Жыл бұрын
Do you think I could install a newer yz big bore kit (2005-2021) to a 1996 yz 125
@theblade4x464
7 ай бұрын
any issue of filling it with silicone instead of tape and playdo, once its dry just rip the whole lot out
@Chris_Does_Everything
7 ай бұрын
Sounds like that would work but I have not tried it. Basically anything that will seal it up and then come back out without leaving a mess or working its way into the crank/bearings will do the trick.
@onthetrowel1895
Жыл бұрын
Is it worth it??
@keefer88
11 ай бұрын
Do you know if the process is the same for the 85 to 112 kit?
@atomlindsey7995
Жыл бұрын
What is the ring end gap supposed to be, I also put a big bore on my 125 but I think I made the gap way to big because it burns engine oil like crazy
@rhyswatson9976
Жыл бұрын
My man twocstowks don’t have engine oil on top end
@onenessseeker5683
10 ай бұрын
You most likely have bad crank seals
@fishing4carp815
Жыл бұрын
Will it work if I return 125cc on moded 144cc case
@Chris_Does_Everything
Жыл бұрын
Yes it will, no issues switching back and forth if you need to.
Пікірлер: 18