How’s the ride quality with the jhms? I really want to drop mine but I drive quite a bit and don’t want to sacrifice the comfort.
@PBGarage
4 ай бұрын
It feels like OEM. This is my wife's car, and if it increased any harshness I wouldn't hear the end of it. She didn't notice a change in comfort, and neither did I. A great cost effective solution for lowering it.
@assassinsairsoft3286
3 ай бұрын
Any update i want to lower mine they said it can affect the shock if you ise lowering spring thank you
@PBGarage
3 ай бұрын
It has been about 15,000km since the installation and not one concern. The OEM struts that have now about 165,000km havent blown either, and it remains as comfortable to drive as before.
@facelessman7733
9 ай бұрын
For the rear, those 2 subframe bolts are one-time-use TTY bolts, and you should replace them for safety. A few dollars is cheap insurance considering how critical these bolts are--it only takes one failed subframe bolt to ruin your day. On the fronts, unless you're replacing the part as you've done, leave the lower pinch bolts in place and instead remove the upper arms and swing them out of the way. On the strut pinch bolt, spend a couple bucks to get a proper spreader tool so you don't risk cracking the strut mount. Otherwise, thanks for your vid.
@PBGarage
9 ай бұрын
Thank you for the reply. You are correct, those rear subframe bolts are TTY, but would have added 200 dollars to the project. As mentioned in the video, I've gone against the FSM on many subframe bolts without negative results. The FSM also states to replace any control arm bolts that are removed. Which I and many others havent either. Good tip on the fronts, that is definitely another option to avoid the pinch bolt if needed.
@JH-sc7cs
6 ай бұрын
Was wheel alignment affected with the rear ?
@PBGarage
6 ай бұрын
I never took a before measurement, but I would say yes.
@bquattrog
10 ай бұрын
What's the top speed on this vehicle?
@PBGarage
10 ай бұрын
It turns into a blur after 130km/hr!!!! so probably 350km at least!
@anthonycraig-pw9oh
10 ай бұрын
What happened to the other two 2.7T builds?
@PBGarage
10 ай бұрын
Stalled pretty hard with other project... like this. We owe it to the channel to complete them... there isn't much left for the stk. Perhaps an update over the holidays.
@booneylander
10 ай бұрын
We’ve actually got a bunch of updates in the pipe for both those cars. A long time coming but hopefully worthwhile.
@anthonycraig-pw9oh
10 ай бұрын
Learned a lot from you guys and really appreciate it. Have just got my re-surfaced 2.8l heads and BF block from machine shop so itching to get it back together.
@anthonycraig-pw9oh
10 ай бұрын
@@booneylander Can't wait to see the comparison between them all.
@booneylander
10 ай бұрын
That minivan looks way better lowered for sure. When will we see a timing chain video on it?
Пікірлер: 17