great videos. Very nicely paced step by step and clear video for those of us who are moderately mechanical. Thanks for putting these together. Will visit again next repair
@awev5233
4 жыл бұрын
This video shows two fuel line - the larger of the two is the pick-up, and the smaller is the return. The fuel filter is on the larger of the two lines. In a lot of cases both lines are the same size - in this case you may want to take a couple pictures with your cell phone, make a drawing, or put a piece of masking tape on the carburetor next to the fitting that the line with the filter attached to it goes.
@Mike-rd4uh
2 жыл бұрын
Which lines go to which ports on the carburetor
@skipperperdue2969
4 жыл бұрын
You didn't show which male line the filter line attached to!
@roypatterson9910
3 жыл бұрын
One thing you should have explained, which is what line goes where, meaning which line runs to to main and the return. I think you should either do another video explaining this, or correct this one. 😁👍
@terencescott3957
2 жыл бұрын
I'm in the process of doing this as we speak. I tried to keep track of which hose went where but got them all twisted around. I noticed on the carburetor one spout is "ribbed" while the other is smooth. I'm guessing the ribbed side is the inlet and the smooth is the return??? I also found it easier to remove the tank vs the air filter. One problem, a nut popped out from somewhere and I have no idea where it came from. I'm thinking it was on the lower screw to prevent it from going in too deep.
@TheGrilledCheeseSandwich
10 ай бұрын
Awesome clean video.👍
@thatguyoverthere8355
2 жыл бұрын
Careful pushing rubber grommet into place with metal screwdriver. Tip can cause tiny punctures, leading to failure. Replacement kit had filter pre-attached to black fuel line. Filtered line goes to lower fitting, nearest to primer squishy bulb. The bent upper fitting attaches to shorter yellow/clear line. I'm guessing nothing goes on the shorter line inside tank, but I don't know why.
@brianward1007
4 жыл бұрын
What line goes to what fitting
@bryangifford8792
4 жыл бұрын
Did you ever find out? I've gotta do this tomorrow
@PREPARED067
2 жыл бұрын
I need a link to my LM-10 REPLACEMENT
@ziyakucuk4082
6 жыл бұрын
Very nice video 📹
@tryingtomake9871
6 жыл бұрын
Nice video. I like this.
@blakeellis1040
4 жыл бұрын
Where do u buy the fuel line kit
@blakeellis1040
3 жыл бұрын
@@AnthroCryptoDoc thanks boss
@watertiteman
Жыл бұрын
Skipped over the only part that needs explanation: which line goes where? Waste of time
Пікірлер: 17