#SKCCNCROUTER #BUANAIMPIAN2 #BATAM
CARA PASANG LIMIT SWITCH
• CARA PASANG LIMIT SWIT...
DUKUNG CHANEL INI SUPAYA BERKEMBANG
DENGAN CARA :
SUBSCRIBE, LIKE, COMMENT, SHARE
TERIMAKASIH DUKUNGANNYA
SEMOGA VIDEO-VIDEO SAYA BERMANFAAT
BAGI SEDULUR SEMUA....
SEMOGA KITA SELALU DIBERIKAN
KESEHATAN,REJEKI,DAN SEMUA YANG BAIK DARI TUHAN YME
AAMIIN........
MACRO Z PROBE MACH3 di copy lalu paste ditempat kalian mau di komputer : di bawah ini macro nya
'SKC CNC ROUTER 26/07/2020
CurrentFeed = GetOemDRO(818) 'Get the current feedrate to return to later
PlateThickness = 19.8 'dirubah ketebalannya sesuai yg dibuat
If GetOemLed (825)=0 Then 'Check to see if the probe is already grounded or faulty
DoOEMButton (1010) 'zero the Z axis so the probe move will start from here
Code "G91 G4 P2" ' two second delay
Code "G31 Z-50.0 F100" 'Z goes down feeding 100
While IsMoving() 'wait while it happens
Wend
ZProbePos = GetVar(2002) 'get the exact point the probe was hit
Code "G90 G0 Z" &ZProbePos 'go back to that point, always a very small amount of overrun
While IsMoving ()
Wend
Call SetDro (2, 19.8) 'set the Z axis DRO ke ketebalan platenya
Code "G4 P0.5" 'Pause for Dro to update.
Code "G90 G0 Z25.0" 'retract Z to 25 mm
Code "(Z axis is now zeroed test)" 'puts this message in the status bar
Code "F" &CurrentFeed 'Returns to prior feed rate
Else
Code "(Z-Plate is grounded, check connection and try again)" 'this goes in the status bar if aplicable
Exit Sub
End If
Негізгі бет AUTO TOOL Z PROBE MACH3
No video
Пікірлер: 54