from Algeria thanks for sharing your precious knowldge sincerly your kindness appear and obvious through your soft voice you're so generous god bless you from my deep heart i applogize for my bad english
@maheralwajih3151
Жыл бұрын
I like his voice, sometimes I us this webinars to learn most of times I use them to sleep ;)
@cuteo7869
Жыл бұрын
Great video, very helpful. Thank you.
@jimmybarus2168
10 ай бұрын
i was created custom symbol, when i put on horizontal symbol keep in vertical position, any sugest?
@stefancoffa5980
2 жыл бұрын
This video was very helpful. However I am having one issue that I can't seem to fix. Whenever I complete a symbol and put it into a drawing, the Pins section of the dialogue box is greyed out and it won't allow me to type in my pin numbers. I did add the wire connections according to the instructions in this video but for some reason the boxes are greyed out for me no matter what I try. I can still add the pin numbers by double clicking the component and entering them that way, but I would really like to be able to enter them the normal way. Any help with this issue would be greatly appreciated :)
@dana.9394
2 жыл бұрын
Really helpful ! Thanks !
@cuteo7869
Жыл бұрын
I'm having difficulty Updating/Sync my attribute to the order I wanted to be. I used the "Symbol Builder" to created my smart blocks, added to the " Icon Menu Wizard", then inserted with the "Icon Menu". The attribute was everywhere of course, that's normal in AutoCAD. I used BATTMAN command to make the adjustment and it was fine, until I used the PURGE command and reinserted the same block to test it out and the newly adjusted attribute was out of wack again. hope someone in here can help me out. Thank you in advance.
@namnguyenquy4332
2 жыл бұрын
how do edit the custom circuit breaker you just created. thank you very much
@sherinrodrigues4022
3 жыл бұрын
hey how to change complete family tags for particular project file ...? family mapping in autocad electrical???
Пікірлер: 10