Mobile mechanical lifter with a possibility to flip over a vehicle
A vehicle is lifted in a centre of gravity under support beams. The jack is purely mechanical, is powered easily by an electric hand drill. Two gearboxes of an advanced design with a help of trapezoidal screws inside the frame ensure a quick lifting or putting the vehicle down again. The lifter can be used with 99% of all vehicles like cars, off roads, pickups, vans, minibuses. The lifter is suitable for all mechanical work, bodywork and painting work, vehicles presentations and exhibitions, car washing (no hydraulics or wiring), tire service. Thanks to the lifting in the centre of gravity it can be easily flipped over by hands if needed on front or rear wheels.
Skids under support beams are adjustable in width for needed width of a vehicle. The product is supplied with pads under the beams suitable for vehicles with a special plastic-covering of beams.
An advantage of AUTOLift 3000 is a complete mobility and compactness. The device is of very sympathetic and compact dimensions. AUTOLift 3000 can be stored at any time if not required and therefore it does not take up space in a workshop. There is a possibility to transfer it even by car to a desired location.
In a small garage it needs only about 1.5 m distance from the side of a vehicle to insert the jack under a vehicle. Also a high ceiling is not necessary in your garage or workshop unlike the traditional stationary 2 or 4 columned jacks.
Technical data:
lifting capacity 3000 kg
dimensions 1635 x 1300 x 120 mm
weight 43 kg
lift 60 cm
lifting speed 25 sec.
Accessories to AUTOLift 3000
a mechanical handle to operate without power supply (including a joint)
a manual electric drill 1200W 230V
a head to a drill for using the jack (4-sides) -- set of 2 pcs
beams pads -- set of 2 pcs
bars for uneven surface
Негізгі бет AUTOLIFT 3000 mobile mechanical lifter
Пікірлер: 19