Are you kidding ?No. of time step is too little .The value of residuals never got converged even in default condition,your analysis has no reference value at all !
@abhilashm6711
3 жыл бұрын
Mr Walter Lee could you share your contact information?
@SANDEEPMANDAL-DEZengineering
2 жыл бұрын
8237799880
@engmahmoud3232
2 жыл бұрын
Hello When I import the fan it shows me many parts and many bodies. How can I merge them and make the fan one part and one body?
@SANDEEPMANDAL-DEZengineering
2 жыл бұрын
USE ANY MODELING SOFTWARE TO MERGE THE INDEPENDENT BODIES. Also we can do it on space claim to prepare stitched surface bodies
@mliquisa
4 жыл бұрын
hey! the video seem great! but could you tell me about the geometry, cause i wnat to know how to draw axial fan. thank you so much
@SANDEEPMANDAL-DEZengineering
4 жыл бұрын
Yes...i will tell u can u call me .get the no. From my profile on KZitem
@SANDEEPMANDAL-DEZengineering
4 жыл бұрын
Or please send me your mail id
@abhilashm6711
3 жыл бұрын
Can you provide your whatsapp number???!
@caufieldholden277
5 ай бұрын
sir, where is your shoud fan, because i think the shroud also affects your stimulation results
@SANDEEPMANDAL-DEZengineering
5 ай бұрын
This is one of my project from OFAJ’ i just replicated the practical conditions here
@caufieldholden277
5 ай бұрын
@@SANDEEPMANDAL-DEZengineering sir, in practical conditions, your axial fan does not have case, right ?
@jamattos9957
4 жыл бұрын
Amazing video, congrtz!! I´m trying to redo your procedure with a different geometry (a turbine) that I drawed, but in the end I´m getting the"FLOATING POINT ERROR", can you help me out? I guess it might be poor mesh quality or large time steps, but I did change those parameters and it and still get this same error...
@sakhilts263
5 ай бұрын
Have you resolved this. Iam also getting the same issue
Пікірлер: 16