I had no problem getting pan off no strap! Just took filer out and seal then it came out not easy but its getting new one back in have not done that yet, will try again tomorrow with more light.
@billahrens1
2 жыл бұрын
Did B&M replace the 1st pan that leaked?
@tjsgarage9650
2 жыл бұрын
Actually.......LEAK WAS FROM REATINER SCREW FOR MAGNET..MAKE SURE YOU USE THE SUPPLIED WASHER..TOLERANCES ON THAT BILLER ALUMINUM IS MINIMAL
@billahrens1
2 жыл бұрын
@@tjsgarage9650 Oh ok. I wish they would make a 2 piece pan. The bottom of the pan could be a separate part that bolts up to the rest of the pan. That way the exhaust pipe wouldn’t be an issue at all.
@billahrens1
2 жыл бұрын
Do you still have the leaking pan? Interested in selling it?
@tjsgarage9650
2 жыл бұрын
@@billahrens1 i have it... I know exactly where the pin hole is
@billahrens1
2 жыл бұрын
@@tjsgarage9650 Do you think it could be welded? How much would you sell it for?
@buckshot4428
2 жыл бұрын
My 14 Silverado needs one of those. GM puts in a thermostat that holds the fluid until it reaches 185 degrees and by the time it runs thru the radiator you're knocking on the door of 200. Add a trailer or a steep grade and you're asking for trouble. Shame on GM>
@tjsgarage9650
2 жыл бұрын
It was well worth the money and actually pretty easy to install..
@ernie548
Жыл бұрын
Nice job. Im thinking of doing this. Is the trans pan now the lowest item under the truck? Maybe it takes more hits from rocks and road debris??
@tjsgarage9650
Жыл бұрын
Theres no clearance or debris issues....all good...just extra trans fluid ..2 qts
@tjsgarage9650
Жыл бұрын
Make sure you use the spacer washers on the magnet....the screw WILL go through the pan without it ...causing a leak
@johnwyatt1321
2 жыл бұрын
Damm good video
@guillermosoriano6487
2 жыл бұрын
Thank You TJ , very informative and well put video.
@tjsgarage9650
2 жыл бұрын
Your welcome..its nit a hard replacement at all..just be sure to use BOTH washers on thebolt that holds the magnet in or the screw will sctually go through the pan...very close tolerances on that step
@guillermosoriano6487
2 жыл бұрын
@@tjsgarage9650 Thank You Sir
@alextrujillo8658
2 жыл бұрын
What is your trans temperature now with this deeper pan that allows for 2 extra Qts?
@tjsgarage9650
2 жыл бұрын
Deeper pan ..2 extra quarts.....didnt add the temp gauge kit though
@rboyett
2 жыл бұрын
@@tjsgarage9650 the truck should have a trans temp from the fsctory
Пікірлер: 29