hi, nice work. is it already working 100%? and how did you make the small hole? what size and what did you use for the round surface?
@86turbodsl
3 жыл бұрын
Small hole was 0.010" drill bit in a dremel on a dremel drill press. No problems making it. The round surface is a brass doorknob from Lowes. I'm working on controls still. I'm probably fussier than most, so i will work on it until it's flawless.
@victoryfirst2878
3 жыл бұрын
Why does the arc go toward the atomized fuel ??? Does the nozzle have a grounded lead to attract the arc ???? Thanks
@86turbodsl
2 жыл бұрын
the arc goes towards the atomized fuel because it's charged and the atomized fuel is essentially grounded. That's my take on it anyway.
@aaronbruckelmeyer
4 жыл бұрын
Does the spark have to be on for the flame to work or can the flame self sustain after things heat up a few minutes?
@86turbodsl
4 жыл бұрын
It's possible to sustain on some burners, but the air flow and oil flow have to be just right for the size of the tube. In my design, not sparking 100pct causes the flame front to travel up and down the tube. Most oil burners keep spark on 100pct of the time. The spark equipment is designed to do that.
@vitaly_shvetsov
4 жыл бұрын
Hello friend , which high voltage module is used (google translate im from Russia)
@vitaly_shvetsov
4 жыл бұрын
automation on the microcontroller?
@86turbodsl
3 жыл бұрын
Standard Beckett style high voltage transformer for oil burner.
@86turbodsl
3 жыл бұрын
Microcontroller is PLC from automation direct. Writing ladder logic to control all burner functions.
Пікірлер: 13