I used the same technique which I learned only tonight to baste around my design. The baste did not pick up my bobbin thread as you demonstrated. My work around was to just lengthen the thread from the needle and it worked. I have a Stellaire .XE 1. I didnt know it was a thing because I’ve always created my basting stitch with Embrilliance software..
@dedrahiggins1326
3 жыл бұрын
Thank you for this! I have been looking at the Meridian and appreciate this information.
@Bc-wq7rv
3 жыл бұрын
This is a fairly common problem on different brand machines as well. Sometimes I have done a needle down, then needle up before starting the basting stitch. Pfaff fixed this problem by adding a tie off stitch at the beginning of the basting stitch around. Good luck and stay safe out there. 🤗
@jeannestiffler2837
4 жыл бұрын
thank you for this hint, I did have this problem with my Meridian
@pjdowell2
3 жыл бұрын
Thank you for this info.
@fbmroberts
3 жыл бұрын
Thank you! I am having the same prob with my new Meridian.
@fbmroberts
3 жыл бұрын
I would appreciate a video on laser needle drop.
@donnaabotsway3552
3 жыл бұрын
I have the Solaris and want to do the basting stitches the size of the hoop not the design Have you got any suggestions I did try in IQ but it only lets you select a stitch length of 4 thanks
@HwnScrapper
3 жыл бұрын
I'm interested in a video that shows how to adjust tension when do edge-to-edge quilting. When I quilt on my Meridian, the underside stitch is loose.
@vickieboteler956
3 жыл бұрын
I am having the same problem with my Meridan. I can’t get it to work even by holding thread! Do you know if there is a fix for this or update?
@thorntoncompanysewingmachi5439
3 жыл бұрын
Baby Lock posted an update to version 1.03 on 8-5-20. It does not specifically address this issue, but it is worth a try if you don't have it. Their support line is 800-313-4110.
Пікірлер: 12