One of the best videos I've seen in explaining pilot bearing noise and diagnosis
@d.thorpe2046
5 ай бұрын
Just got a pilot bearing question wrong on a practice test. this was the best video for explaining I found. thank you.
@paulkelley86
5 ай бұрын
Glad it helped, I do a lot of that so take a look at my a3 Playlist and you will find more. Consider subscribing.
@d.thorpe2046
5 ай бұрын
@@paulkelley86 I just subscribed. Thanks for the great content.
@elijah2345
6 ай бұрын
So my clutch pedal is not disengaged (clutch is up) and I hear a really loud noise. When I push it down it goes away.. So, I start to accelerate and I can hear it very distinctly all the way until 3rd gear.. I would love to send a video to you.. You're the best mechanic I've found with a video so far
@bappo5492
3 ай бұрын
That’s most likely your throwout bearing
@elijah2345
3 ай бұрын
@@bappo5492 it's not.. Because throwing bearing is only when your clutch is engaged (pressed in) when the clutch is out it's the input shaft bearing that makes any noise. I found the solution but I'm not paying 6k for a rebuild
@razowazo5958
2 ай бұрын
@@elijah2345what did you end up finding??
@terrienhumain6723
7 ай бұрын
It is helping, thank you.
@na0h1t0n2
2 ай бұрын
very helpful! thank you.
@ladyeparker2470
Ай бұрын
Thank you very good explanation
@seigneurdesbouseux6603
25 күн бұрын
very good explanations
@barbossajacksparrow9481
2 ай бұрын
Nice description
@KostadinDelizhanski
7 ай бұрын
with lightened flywheel, most cases the transmission input shaft bearing will chatter also just another thing to consider
@webpro607
4 ай бұрын
does VW Jetta/Golf (2012) with manual transmission has Pilot bearing?
@sjgoff
Ай бұрын
Nissan KAs and SRs use pilot bushings, not bearings. That sounds like a throw-out bearing noise. The harder you press on the clutch - the more pressure is put on the bearing hence why it gets louder, the harder you press the clutch.
@cryptocreweLINK
2 ай бұрын
What if it’s the opposite way? I get noise when I let clutch out
@rcary
2 күн бұрын
Hi, i have a Renault over here in the UK. My clutch has plenty of bite, and drives fine, but makes a funny sound like a iron gate creaking for a split second. It usually happens when downshifting and not under load. If i coast in say 3rd, put clutch in and lift it slowly, about 3/4 the way release i get the little creak noise. It doesnt do it when in neutral and releasing the clutch at any time. Its almost like a dry rubbing sound that only shows up when driving and shifting down will no throttle. Any ideas? I attached a vid link, maybe someone here has experienced this. Thanks! kzitem.infoEUoQARr_FdU?si=C2ogwNREM9aZS10r
@mugz90
12 күн бұрын
My car is automatic a 2014 infiniti q50S hybrid RWD and once I'm driving between 5mph and 20mph I hear this kind of sound. When I press my brake and come to a complete stop the sound goes away
@paulkelley86
12 күн бұрын
Sorry, you will need to have that diagnosed by a good repair shop. You vehicle does not have any of the bearings in my video. Your automatic is completely different than a manual. A good shop will charge you diagnosis time but if they correctly diagnose the cause, it is well worth it. Paul
Пікірлер: 20