I'm still using my oem retail chain on a bbshd 1000 watt still holding up. Nice build there friend,!
@mowtown75
Ай бұрын
@@patrickoneill1011 thank you appreciate the compliment and input for others.
@shadesinblack1
22 күн бұрын
I've had a similar setup for a couple of years. The shift sensor for cutting off the motor wors really really well. It performs the same like you do manually, but automatically. I don't have the brake cut off sensors since the motor cuts off almost immediately when you stop pedaling. It's normal that you read 52v or so when the battery is fully charged. 48v is just the nominal voltage. When it's "dead", it's around 42-43 I think.
@mowtown75
20 күн бұрын
@@shadesinblack1 This is great information and thank you for sharing it with us. The brakes scenarios makes sense, it does cut out as u say. I will check out the shift sensor.
@zangl2955
17 күн бұрын
I was depressed and smoking too much pot for months. Sitting around bored. Now im gonna save my money and make my bike go fast instead.
@mowtown75
17 күн бұрын
@zangl2955 An excellent response to one’s struggles, and lifestyle choices. There is a link between pot and depression, and also schizophrenia if used long term. Now is the time for change well done, I respect that. Btw riding an e-bike can be addictive, a healthy addiction! 😀
@CapNemoDRS
2 ай бұрын
nice conversion
@yzdzer
Ай бұрын
Hello, I would like to know if I can mount the bafang bbs02b 750W kit on the giant bike Giant - Trance X2 2010 thank you
@mowtown75
Ай бұрын
Hi, The width of your bottom bracket (Hub the the pedals connect through) needs to be between 68-73 mm. Mine was 73mm and it fit. The 73mm will only take the one lock nut, it will not have enough thread protruding to take the additional aluminum collar, (this is normal & ok). See ae01.alicdn.com/kf/Sfcd2d256dde84b39bece09f5c620944bN.jpg I am concerned about the battery though, it may not fit inside where the drink bottle mounts, you will need to research that, I will try and come back with the dimensions of the battery. Mine did fit, but it did not line up so I had to drill into the frame to mount it. Advice based on your bike as shown here; ecmtb.net/t/2010-giant-trance-x2-sold/6471 Thx Tim
@yzdzer
Ай бұрын
@@mowtown75 Great thank you for your answer, indeed unfortunately I think that for the battery it is impossible
@mowtown75
Ай бұрын
@@yzdzer You can get a rear carrier for the battery :)
@tennyboy13
16 күн бұрын
@@mowtown75what did you use to screw your screws in after you drilled the new holes? Thank you!
@mowtown75
16 күн бұрын
@tennyboy13 I ran stainless steel 5 mm bolts all the way thru the bar and nuts on the underside. I did still use the drink bottle threads for the other two screws that are under the battery holder cover. Let me know if u need a video.
@randomguy5284
Ай бұрын
Sorry if I miss this but how much does the conversion cost? I’m planning to convert my mountain bike. Thx
@mowtown75
Ай бұрын
Allow about AU$1000 all up. I shall put the AliExpress store that I used in the more section. Reach out if you need help :)
Пікірлер: 18