1962 C10 Chevy Fleetside short bed. This was an original short bed truck with the vin on the frame matching the cab. This was a super clean original truck before the full frame-off build began. Drip rails, floors, quarters, etc. everything on this truck are solid. Has a great original patina without looking too trashed or overdone. This truck was completely stripped-down and the chassis was sandblasted before all modifications were performed. Custom barnwood was found to create the bed floor and was cut to fit then cleared with a matte finish to preserve its original look. Front and rear patina bumpers were found and installed along with rare front bumper guards to match the great patina of the truck’s original grill and hubcaps. All custom bead rolled inner fenders were fabricated along with rear wheel tubs to match inner fenders. The truck also features brand new glass, seals, felts, rubber, etc. along with LED taillights, running lights, signals, and headlights.
Truck has full Porterbuilt custom front and rear air bagged suspension in addition to a full Accuair E-level system with automatic leveling arms that make this truck super simple to drive and operate. The 9” received a full rebuild along with 3:73 gears and posi added along with a custom 2 piece drive shaft with slip yoke. Wheels are aluminum Coys smoothies that measure 20 inches on all 4 corners. A CPP big brake kit was installed that includes drilled and slotted rotors along with 4-piston calipers on every corner.
Vintage Air was added along with Dakota Digital gauges to create some creature comfort for long cruises. The inside of the cab was smoothed and painted along with the firewall, while some of the unneeded holes on the firewall were filled to clean up the presentation as well. A Bluetooth head unit was installed in the dash along with full custom stereo which includes 6.5” kick panel speakers, 6x9 Infinity speakers in the rear behind the seat, and a 10” JL audio sub behind the seat. The interior was also done way over the top with only real leather used throughout. The center transmission tunnel was covered in leather to give it a unique but clean look to stand out over everyone else. Carpet is a high end custom square weave wool with custom floor mats created to match. The seat is a modified Escalade seat and also still folds forward for storage and includes a folding convenient center arm rest. The steering column is a tilt Flaming River setup mounted to the power rack and pinion. A brand new steering wheel was painted to match the interior along with the custom painted lower AC vent create a very finished and tidy interior detail.
An American Autowire harness was used for the wiring of the entire truck except the engine and transmission harness which are Speartech. The engine is a 2018 5.3LT direct injected all aluminum engine to create something unique rather than the standard LS swap. This engine is from the new LT platform GM uses on their new trucks today and is mated to a 4l60 automatic transmission. The gas tank was made by No Limit with all the equipment needed to handle the direct injected engine.
Insane hours were taken to bring this truck to the next level and allow it to standout from other builds. Full build pictures and videos are available. The truck only has 1300 miles since build and gets so much great attention and appreciation everywhere it goes. Absolutely zero corners cut throughout the process.
Негізгі бет Bagged 1962 Chevy C10
Пікірлер: 28