I want to know how many things can make a peak finish like a helix (45' ?) , Rake angle 10 , 20 ' ? , Cusp Height, step over, Wiper ( I heard that Nissin ball nose design like insert wiper, etc... why mention only cutting way, not mention the other factor.
@chip-load
8 ай бұрын
Where is the formula to correlate step-over to cusp height or RMS? Wasn't that the point?
@CuttingtoolCounselor
8 ай бұрын
You can get the formula off our resource page at Helical or Harvey. But our Machining advisor Pro calculator will do the calculation for you. Ctc
@arbjful
5 ай бұрын
So can we use ball nose end mill to surface a flat piece of aluminum 10 mm thin ?
@JohnStoever
9 ай бұрын
Excellent. I've been waiting for this video.
@muralinaik6511
8 ай бұрын
Thanks don! Great episode as usual... Thank u.. Curious about the upcoming episodes to see greater surface finish😊..
@CuttingtoolCounselor
8 ай бұрын
Thanks for supporting the channel. Ctc
@JohnBlaze505
8 ай бұрын
Yes! Been waiting for this one. Then you get into accelerated finishing tools and it gets even better!
@CuttingtoolCounselor
8 ай бұрын
That is the path!!!ctc
@JohnStoever
9 ай бұрын
You didn't tell me anything I didn't Know. But thank you anyway. I always listen.
Пікірлер: 12