This channel is a blessing ! Everything is explained in detail !
@stevesirak
Жыл бұрын
Nevermind I take it all back... take off your caps... I just did my caps one was at 87 and the other one was 12 finally got this figured out thank you I've been jetting up down all around and the whole time it was a bad spark plug cap. Lol
@TheRedLava
6 жыл бұрын
Thank you so much for sharing you knowledge! Been able to detect the problem with my FZ6 S2 with your video ;) Checking your channel to learn a bit more!
@coyoterob2839
3 жыл бұрын
My ignition coil reads at 9.8 ohms could it just be the pack or the caps or wires? Connection? I need help thanks
@MrSliazafoxx
8 жыл бұрын
thanks for the videos! great job
@WestCoastRoller
8 жыл бұрын
Thanks for sharing
@BrandonRossVlogs
Жыл бұрын
When I read my wires it doesn’t say anything I tried cutting the wires shorter for new cable and still nothing is it bad ?
@yvonjasser
7 жыл бұрын
Thanks for this video, I guess it would be the same for rd400 cdi, rd350lc and rz350.
@xxDONMEGAxx
4 жыл бұрын
Can you give me your thoughts on my readings ? Primary .9 Secondary 6000 Plug cap 1 . 5700 Plug cap 2 . Won't read Banshee intermittentantly wont run . Obviously getting new plug caps . Spec on primary is .28 to .38 and I am at .9 , is this coil good still ? Primary is a little high but not terrible , thanks anyone for your thoughts
@tryhardgta8075
3 жыл бұрын
Mine reads 16k ohms about 3x higher anything I can do to fix that I was thinking trim the wires they are about 2feet long
@nathansena3542
3 жыл бұрын
So my primary is reading 0.6 is that bad? Secondary reads fine though.
@givennameidk4515
8 жыл бұрын
Nice.
@Wereallthieves122
4 жыл бұрын
Hey bud, Super helpful for the Banshee! not sure if you said in the video, but do these same ohm readings work for testing blaster coils?
@joemercedes4503
6 жыл бұрын
Hey bro, when I test the primary I don’t get any ohms like you did, if I test cont the dvom beeps which means there’s cont... is the coil bad or am I doing something wrong? The meter at 200k ohms literally reads 00.0 ohms. The secondary gives me 5.4 and the cap gives me 5.8 like yours.
@kevingalindo1
6 жыл бұрын
joe mercedes Try it set to 20K, see what happens. I believe that’s the setting you need, mine is auto ranging so I don’t have to mess with it.
@joshjensen3292
7 жыл бұрын
I test the ignition coil and said 0.9 down 0.5 is it good ??
@emmanuelgamez6318
7 жыл бұрын
hi ran the test got a good read on primary but secondary no reading neither plug either but the bike was running fine except for the right side it would just spit out fuel what should i do???
@seamlessny2720
7 жыл бұрын
Emmanuel Gamez spitting out fuel because it isn't firing change your secondary and cap.
@heinenbr00
6 жыл бұрын
Emmanuel Gamez
@Adam-zo6lc
2 жыл бұрын
Thank u!
@bflobusa1225
8 жыл бұрын
Would you happen to have 2 banshees you would trade for a 2006 gsxr 1000? I am located near Austin
@kevingalindo1
8 жыл бұрын
BfloBusa 1 nah man i sure dont
@modifiedworkz_
7 жыл бұрын
So would a bad cap like that make it miss fire
@seamlessny2720
7 жыл бұрын
murdahteam no fire at all
@truth1267
7 жыл бұрын
got nothing on home for my secondary but on 20k setting I got 6.05
@ryeguy4449
6 жыл бұрын
Wellington Bajana me too did you ever figure out what was wrong?
Пікірлер: 28