That unroller works great in the wide open spaces but not so much when running or repairing fences in the woods. Also, I've used either a power winch or the tractor to put a bit of pre- tension on the wire before using the Goldenrod. Working on fence lines in the woods though, the technique you demonstrated here with the Goldenrod is about the only way to go.
@brian8410
Жыл бұрын
I don't like to wrap the wire around the end post tie off that many times. If you need to retighten that wire is is hard to work with again. 2 turns is plenty.
@nelsonferris2606
Жыл бұрын
Let that roll of wire on the ground. The ground acts as a brake.
@dylancyprian843
Жыл бұрын
Huh I’ve never seen the clip bender in action pretty handy
@PapaRug.58
Жыл бұрын
Good idea using the 3pth wished I had seen this before built a rack for the front of the quad but backing up is hard on an ol guy like me lol
@fxpestoperator5527
Жыл бұрын
Great Video Brother!!!!!!!!!!!!!!!!!
@joedoakes8307
Жыл бұрын
Hint.........put an old disc on each side of the wire roll . It will , most times keep the wire unspooling from the roll !
@ginohidalgo1646
Жыл бұрын
You’re hilarious
@conradbolton9232
Жыл бұрын
Go halfway back to the post your tensioning from after you have put the initial strain on, pick up the wire and lean back on it as hard as your body weight will allow. Then go check your tensioning again and you'll be surprised.
@conradbolton9232
Жыл бұрын
Off a post go 5 loose then 5 tight. Joining do the same both ways.
@abbo3272
Жыл бұрын
See if high tensile barb, is available in your area, much better, as it wont stretch, that wire, will go slack in no time.
Пікірлер: 31