If you want to know whether it works or not , you will need to use it on old wiper blades, which is in use for > 2 years, where the wiping is not even anymore leaving water droplets or wipe lines on the glass. 1. Grind the wiper blades using the rough side first, for several times (4 to 5 times), back and forth for the entire length of the wiper blade. You start from 1 end to the other end of the wiper is consider 1 time. Avoid stopping in the middle and pull back, follow through towards from one end and back to the other end to ensure an even grind for the entire length of the wiper blade. 2. Now, repeat the above step 1, using the Fine side. 3. Now that 1 wiper blade is done, and then you can do the same for the other wiper blade of your car. The principle is similar to sharpening a knife. The rough side helps removes tiny debris or unevenness of the rubber surface of the wiper blade. And the fine side will smoothen the entire surface.
@hswee2000
Жыл бұрын
agreed
@jesswang03
Жыл бұрын
I was initially curious about the wiper sharpener but now I’m curious about the VIP McD sticker
@hswee2000
Жыл бұрын
hahaha.. that is funny 😅😅☺️
@jayem1826
5 ай бұрын
Me too
@danc1197
Жыл бұрын
Ironically it's the summer sun that wears out your wipers. Rain doesn't wear out rubber because it's always lubricated. The heat from the sun causes the blades to dry up and crack before the winter starts. The best solution is to wax or polish the blades during the summer and they will be soft and ready to use for the following winter.
@alvinkuo
Жыл бұрын
The wipers before repair seems quite ok, maybe that's why not much improvement after using the tool to sand the wiper blade.
@hswee2000
Жыл бұрын
i m not recomend to buy this as really need skill to sand or grind off evenly .
@anastasiakhudzyk123
Ай бұрын
For me as well. Did change a little bit but not too much.
@hswee2000
Ай бұрын
agree with you 🫶🏼
@nicholaslandolina
Жыл бұрын
Same
@s.h.k9188
Жыл бұрын
Sharp blades are impossible to cut straight rubber and will leave behind jagged and bumpy rubber surfaces, even if they are delicate It is better to buy new rubber, even if it is cheap to work efficiently
@hswee2000
Жыл бұрын
agreed with you.
@diablosrobos
6 ай бұрын
thank you bro.. now i realize that i have been scam..😂😂😂
@hswee2000
6 ай бұрын
haha.. my advice just buy new wiper at Mr DIY 🤣
@diablosrobos
6 ай бұрын
@@hswee2000 hahaha.. indeed.. luckily i didn't buy but use my lazada points to purchased 😂😂😂
@Bob-bw6to
11 ай бұрын
You can tell op is Singaporean just by the title
@hswee2000
11 ай бұрын
😂 haha
@zaidzailan1
5 ай бұрын
Apa beza rough dengan fine?
@hswee2000
5 ай бұрын
rough tu first wipe dan lepas tu pakai fine utm buang burr kasar
@amieram138
2 жыл бұрын
Sama ja aku tengok.. makin teruk ada lah
@hswee2000
2 жыл бұрын
bagi sya baik tukar baru punya wiper 😅
@amieram138
2 жыл бұрын
@@hswee2000 betul.. hanat betoi siapa cipta benda haram tu
@hswee2000
2 жыл бұрын
@@amieram138 haha.. entah lah tu. main cipta je tu 🤣
@rijantyruby7633
Жыл бұрын
😅😅😅😅😅
@JonValerT
Жыл бұрын
it really doesnt help at all. i also have this one,
Пікірлер: 29