lapping length, lapping length in beam, lap length in column, overlapping length in column, lapping length in slab, development length, lapping zone in beam, lap length in beam, lapping zone in column, lapping length in column, lapping in beam, lap length formula, lapping length for beam, basic rule for lapping length in column, basic rules for lapping length in rcc columns in telugu, overlapping length of reinforcement as per is code, what is lapping length
#civilguruji #civilengineers #Beam #Lapping
Basic Rules for Lapping length in Beam - Lap length in RCC Beam
For Training Call Now : 8851206936
ABOUT THIS VIDEO :-
In this video Er. Arshad & Corporate Trainer of Civil Guruji (Civil Engineers Training Institute) is Explaining About Basic Rules for Lapping length in Beam - Lap length in RCC Beam
The perfect zone for lapping is where the moments remain zero for continuous beams or in the bending moment diagram, where the values surpass the x-axis or remain at L/4 for simply supported beams. The lapping should be provided on tension zone as moments will be created with greater tension.
Lap Length | Lap length of Beams | Lap Length of Slabs | Lap Length of Columns | Lapping Zone of Beams and Columns. Lap length can be defined as the length that is provided so as to allow the overlapping of two reinforcement bars thereby ensuring safe and efficient transfer of load from one bar to another.
When we provide lapping in a column, all the rebars should be lapped in zone-B as shown in the drawing. The top and bottom portion of the column, i.e. zone-A ( L/4 length ) should be avoided as there will be a maximum moment in this zone due to lateral forces acting on the column.
This amount of overlap between two bars is called “lap length”. Lapping is usually done where minimum bending stress is encountered. In general, lap length is 50d which means 50 times the bar diameter, if both bars are of same diameter.
Негізгі бет Basic Rules for Lapping length in Beam - Lap length in RCC Beam ||
No video
Пікірлер: 1