Thank you very much, your video was a massive help 👍
@mrfxr1695
27 күн бұрын
Your welcome 👍😉
@normareed9007
Жыл бұрын
Beautiful. What an improvement on what you ripped out.
@mrfxr1695
Жыл бұрын
Thank you! Cheers!
@Chris-uu6dg
4 ай бұрын
Nice work thanks for your video 😃
@mrfxr1695
4 ай бұрын
Thanks 👍🙂
@derrickknight4985
Ай бұрын
Why not turn the bath overflow outlet pointing downward and cut the pipe to fit?
@mrfxr1695
Ай бұрын
This particular pipe/hose has both ends with smooth sections to fit on the spigots with o-ring. Cutting the hose could jepordise the seal
@andrewheale4738
9 ай бұрын
Good work, what blade did you have in the grinder i.e. metal cutting or stone/ceramic?
@mrfxr1695
9 ай бұрын
Thanks 👍 I've used thin kerf stainless cutting blade, similar to one below amzn.to/49M5MNG I found that anything thicker will melt plastic to much and anything with teeth ( circular saw, jig saw,..) can crack and shutter it
@JohnSmith-rw2yn
Ай бұрын
I literally just need a video of how to fit these stupid clips and how it supports. and the camera is only there for a second and fast forwarded. 😅😅
@mrfxr1695
Ай бұрын
Have a look at 5:21 point on the video. It is shown there All the best 👍
@JohnSmith-rw2yn
Ай бұрын
@@mrfxr1695 Cheers, I checked yesterday and the clips are from B&Q armitage shanks universal, they don't seem the same as yours, what I ended up doing was, the old panel slotted between the timber frame and a skirt they have put on, so I unscrewed the skirt, put panel in place then drilled the skirt back on, going no where that and left the clips. Cheers for reply though 👍🏻
@mrfxr1695
Ай бұрын
@@JohnSmith-rw2yn sounds like you've sussed it all out, not bad at all 👍
Пікірлер: 16