BEAT FI DIGAS NGEMPOS || HOW TO OVERCOME MIL 12 & 7 BEAT FI CODES without a scanner using jumper cables
on this occasion I found a beat street fi motorbike whose basic engine is the same as the beat fi esp and almost the same as the previous beat fi too
In this case, the motorbike deflated when it was gassed.
The gas was delayed and less responsive. At first I thought that the problem was the TPS sensor or weak fuel pump.
However, after the DLC socket is jumpered, the error code MIL 12 (injector) and code 7 (EOT sensor) are visible.
Let's go straight to the crime scene... by checking to see if there is a broken or poorly connected cable between the two sensors up to the ECU socket.
and apparently none of the cables were cut
then do a manual reset.
and after resetting it manually it was successful and the motorbike returned to normal until I was amazed at what actually happened.
For suggestions and criticism, you can write them in the comments column, friends
thank you, hopefully it's useful
don't forget to support LIKE SHARE N SUBCRIBE 🇮🇩🏁💪
#beatfi #honda #beatstreet #injection
Негізгі бет BEAT FI DIGAS NGEMPOS || HOW TO OVERCOME MIL 12 & 7 BEAT FI CODES without a scanner
Пікірлер