To hold small screws to a screwdriver use a piece of blue tack
@rogue277
4 жыл бұрын
I just did the same mod a few days ago. Well done! I had trouble getting the motor installed, getting past the belt.
@OpticsCentralAustralia
4 жыл бұрын
Well done - it gets really fiddly at times. I was mucking about for a while with two long pairs of forceps. Then I dropped a screw. Magnets help!
@alanlarson9324
3 жыл бұрын
I used a long vascular clamp with electrical tape around the ends to soften the edges of the tips that would contact the belt. The clamping pressure was low enough that I was not concerned about damaging the belts and it was like having an extra hand down in there where there was so little room for my large hands.
@OpticsCentralAustralia
3 жыл бұрын
Oh, I like that idea! You can see from the video that even with the long forceps it was quite a fiddly bit.
Пікірлер: 5