I’ve found that wiping it down with isopropyl just prior to the bed heating up (where you see the alcohol create a faint bit of smoke while evaporating) further enhances bed adhesion
@miraclo3
5 ай бұрын
This is the way. I literally wipe it down with alcohol and a fresh paper towel every single time and I've never had a print failure in years of printing.
@cslabz
5 ай бұрын
Exactly🔥
@Night_at_sky
5 ай бұрын
Or you could just like, get a high adhesion build plate, I can literally lick my Anker make build plate and it still prints beautifully
@christopherfrawley2560
5 ай бұрын
Soap and water. You need a surfactant to strip oil that creates a barrier on top of your build plate.
Пікірлер: 5