Welcome back to part 2 series on Best Impact Driver bits.
If you haven't seen part 1, watch it here: • Best Impact driver bit...
I don't know about you, but I use an impact driver when ever possible. So bits are important when it comes to transferring that power into the fastener.
In this video we are bringing into the series of tests some of the most requested premium bits from Milwaukee, Wiha, Wera, Bosch.
Milwaukee Matrix Carbide bit
Wiha Terminator bit
Wera Impactor bit
Bosch Impact bit
For the test we drove 100 griprite 3 inch PH2 exterior screws into 2x4 and landscape lumber.
For the test we used the Dewalt DCF887 and Milwaukee Fuel 2853 impact drivers.
Later on start with the bosch started using the Makita XDT14. Will get more into this later in a different video.
Each impact driver bit drove 100 screws back to back (no rest in between), alternating impact drivers.
All the screws and bits used in the test were brand new, and purchased with my own funds at my local hardware store. This video was not sponsored and I am not affiliated with any of these companies. I hope this video was helpful, and we'll see you guys.... NEXT TIME!!!
Instagram: / ak4thewin
Twitter: / 4thewin8 | 4thewin8
Site: www.vlog.4thewin.net/
Негізгі бет Best Impact driver bits | Part 2 | Milwaukee vs Wiha vs Wera vs Bosch | Matrix Carbide
Пікірлер: 108