The Y branches for most units are only allowed to have the branch portion go off 15 degrees of horizontal, and some as much as 30 degrees horizontal. The Y branches here are coming off at a full 90 degrees top and bottom. This particular way is actually mentioned in the manual as not allowed.
@Technoboltic
2 жыл бұрын
It-s a ceiling, mate )))))))
@Astrojamus
3 ай бұрын
they look flat to me
@Jason-wc3fh
3 ай бұрын
@@Astrojamus I hate to say it but you're right. This is a ceiling view of them, so they are correct.
@enayatali9329
5 жыл бұрын
Nice working with Ali Bhai
@turguthuseynov5230
3 жыл бұрын
The things is liquid line should be less in diameter rather that gas line. In your case liquid line is 19mm, but gas 12-07. Why ?
@arcad1an292
4 жыл бұрын
Incorrect piping
@joaquimribeiro9118
2 жыл бұрын
linda instalação
@jomonjoseph7013
2 жыл бұрын
Good job
@ManishKumar-zh6gk
3 жыл бұрын
Mr. Sood site ludhiana
@GovindSingh-gi2vr
5 жыл бұрын
Y joint yese nahi lagta h
@GovindSingh-gi2vr
5 жыл бұрын
Glat pipng h ye
@baraovrf
4 жыл бұрын
Show
@m.haslam8495
2 жыл бұрын
That's a big thumbs down. If you don't know how to fit VRF / VRV Pipework, leave it to the experts. Otherwise, could be a very expensive mistake. There is only one way to do this type of pipework and that is the correct way.
@sayyedansari7768
3 жыл бұрын
Bhai koe vrv ka kam b Data Hii Lucknow ma no 9721349257
Пікірлер: 18