And once the top is off, you can install a vent to tray anti-vacuum valve which Bezzera seem to have overlooked on their $2.5k+ coffee machine.... Also, make sure you DO NOT overtighten the screws holding the side panels on. The perspex expands with heat at a different rate to the metals in the machine resulting in extremely loud cracking sounds when the machine is hot and for 2-3 hours after it's been turned off. A light nip up of the screws is plenty.
@hound83
2 жыл бұрын
Really interested about your comment regarding the anti-vacuum valve, what does this do and how and where would i add one to my machine with what benefit? (i really dont know it and i am curious to know)
@noidle22
2 жыл бұрын
@@hound83 the plumbable anti-vac goes in the position that the factory anti-vac occupied. You would need to make a line to run to the tray, on the Matrix there was already an over pressure valve line that I teed into. Advantages of them is that no steam or water is leaked into the machine internals on startup. It is a fairly small amount but some machines vent worse than others depending where the valve is positioned on the boiler. I recalled seeing vapour on the insides of the panels on mine and figured that's not great around the delicate electronics in it so I fitted the plumbed anti vac. I sold the machine about 2.5 years ago, it's still working fine as far as I know.
@anildegirmenci6908
9 ай бұрын
Hi, do i have to remove the pump from the motor to get the watertank platform out? Because the pump is stuck through the holder and i dont see any other chance to get it out. Thanks.
@Maybaby1959
8 ай бұрын
Believe me compared to other machines. It would be a job I can’t see that ump being so quiet after awhile it’s Cramed into there with a hook and screw capacitor siting on top of it like that. I see in other videos of people pulling shot- the pump sounds like a vibratory in other videos it’s quieter. Idk about this model. In 6 years no updating. That could be a good think. But. I got turned off when he opened it. It looked like when the controller was pulled out everything else fell out. ??
@Displays.1234.
2 жыл бұрын
Having problems with my bezzera matrix de display randomly doing it own thing, not sure if it's the display or the main broad....
@1st-lineequipment
2 жыл бұрын
Please contact your vendor to confirm on how to move forward.
@sleepyjoe8622
3 жыл бұрын
What would cause the display to need to be replaced? I currently have a 2018 Duo and there are areas of the touchscreen that don’t work like the OK. Would this be the display or the control board?
@Displays.1234.
2 жыл бұрын
I now have the same problems with my bezzera matrix de the machine has a mind of its own, did a new display fix it ???.
@sleepyjoe8622
2 жыл бұрын
@@Displays.1234. Yes it did!
@Displays.1234.
2 жыл бұрын
@@sleepyjoe8622 I'm just hoping trying to get a display fixes the problem, because machine has now got a mind of it's own and keeps going through the menus by itself...
@sleepyjoe8622
2 жыл бұрын
@@Displays.1234. that’s what mine was doing. After I replaced the display it works perfectly. It wasn’t very difficult to change either. I hope you can get yours fixed!
@Displays.1234.
2 жыл бұрын
@@sleepyjoe8622 cheers thank you waiting for my new display now...
Пікірлер: 17