That`s why you should never run any carb without a filter ,me thinks you might be looking up changing the exhaust tailpipe angle exit and a deflector of somekind , can`t wait to see what you come up with ,nice one
@user-gw2xw2xb2k
Жыл бұрын
Ey up Steve, when are you doing part 2 of this video? I’ve got clubman sport to fit but not sure I want it now after seeing this video!
@TheSteelweasel
Жыл бұрын
Waiting on materials for project ..... and some inspiration
@SsSs-xl8iw
Жыл бұрын
Interesting 👍👍
@keithappleyard1915
Жыл бұрын
It was odds on this would be the case Steve, that's why I stayed with the ex box on both of mine.once again BGM fail on an exhaust system. V4 was crap with a mid range flat spot, the sport works but covers everything in shit.
@kevinhendon
Жыл бұрын
Interesting Steve 👍👍👍👍
@nickbarber4222
Жыл бұрын
All of the curly exhausts do this 👀
@Lambrettist
Жыл бұрын
A fair few exhausts also leak a the flange, e.g. JL TS1 flanges with the slip on fitment of the pipe, there is always blowback from there. What can I use to seal that? I've tried silicone, "exhaust sealant", etc, everything gets blown out eventually.
@TheSteelweasel
Жыл бұрын
String and exhaust paste does the trick , feed it into the flange so it sits inside at the bottom with the sealer and that's your seal .....
@Lambrettist
Жыл бұрын
@@TheSteelweasel The bottom, do you mean all the way up into the flange? Or do you mean down toward the edge of the flange where the pipe goes in
@martinknight8631
Жыл бұрын
That's disappointing, I've only just fitted one to my 200. Maybe an extended tail pipe is in order?
@Zacky12345
Жыл бұрын
I have one of these😂
@Zacky12345
17 күн бұрын
Did you modify said exhaust?
@TheSteelweasel
15 күн бұрын
No I'm building my own
@markbegley8327
Жыл бұрын
If the carb and ignition are set correctly, well then ,how can you blame bgm for the faults you have found 😮😮
@TheSteelweasel
Жыл бұрын
I think you will find most lambretta are set up slightly rich to compensate for the crap cooling . But no matter how good it's set up you still have heat and smoke and un burnt oil . Bgm did not design it so it's not a dig at them it's a simple over sight , they are still a good exhaust and reasonable noise level .
@TheSteelweasel
Жыл бұрын
I think you will find most lambretta are set up slightly rich to compensate for the crap cool . But no matter how good it's set up you still have heat and smoke and un burnt oil . Bgm did not design it so it's not a dig at them it's a simple over sight , they are still a good exhaust and reasonable noise level .
@grahamherbert3612
Жыл бұрын
That BGM pipe is very badly designed. To be honest, the more BGM parts I'm handling lately, the less I'm liking them.
@TheSteelweasel
Жыл бұрын
The quality is good compared to what we had in the 80s from af rayspeed?????
@Jackintheshed
Жыл бұрын
Your carb is a bit close to the fan
@TheSteelweasel
Жыл бұрын
The carb is not in position, its removed to access the bolt at top of cover .... it also runs with a filter ????
@Jackintheshed
Жыл бұрын
@@TheSteelweasel I know I was being funny I go in there before someone says about it lol
@ScooteristFellini
Жыл бұрын
I have similar, not as bad as yours though. Mugello with a phbh28 filter on an elbow with a drain pipe. To be fair, its quite common on curly pipes in general…
Пікірлер: 24